Electronics Forum: smema and feet (Page 1 of 3)

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 20 15:00:26 EDT 2016 | awhite

Got it!!!!! On the main Operator Screen for the MPM UP2000, and under configuration (when logged-in under maintenance), it gives you ONLY the settings that the machine is set to....there are no drop-downs or options available to choose from. Very fr

MPM Up2000 and SMEMA

Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas

here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin

Re: IPC and Nepcon

Electronics Forum | Wed Nov 18 14:42:22 EST 1998 | Dave F

I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from year 2000. Can anyone tell me if this is true Nick: SMEMA and IPC are talking about merging (EP&P, 11/98, p 18). Below is a news release

Altitude and solder voids

Electronics Forum | Thu Nov 01 10:57:34 EDT 2012 | kris1128

Has anyone heard whether the elevation of a plant can effect solder joint formation? One plant at sea level, one at 7,000 feet elevation... same equipment and profiles, big voiding defects at higher elevation. I did a search and found no similar post

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 13 10:00:27 EDT 2016 | awhite

Switched out the mech. relay on the board loader, no change. Same behavior. Could not find a mech. relay on the printer... SMEMA wiring appears go directly to a PCB. And it is at that point that I run out of talent. If the machine weren't dedicate

IPC and Nepcon

Electronics Forum | Tue Nov 17 15:33:26 EST 1998 | Nick

I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from year 2000. Can anyone tell me if this is true

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas

board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas

that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.

MPM Up2000 and SMEMA

Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t

Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite

Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece

  1 2 3 Next

smema and feet searches for Companies, Equipment, Machines, Suppliers & Information