Electronics Forum | Wed Jul 12 09:50:33 EDT 2006 | nitro
The conveyor program in the Allen Bradley PLC may be bad. I think it is a Micrologic 2000. You may have to re-program it using a hand held unit. Can't halp You with the Pana. I'm a Universal kind of guy.
Electronics Forum | Tue Sep 14 17:49:36 EDT 2010 | g2garyg2
The problem with the Sunsda units is that they use a special circuit board, not PLC and Chinese software for programming, so getting into the program to find out what is going on is a problem. Have you replaced the SMEMA cable? I have seen bad ones.
Electronics Forum | Mon Jul 20 11:46:18 EDT 2009 | msherwood
I’m having trouble with the transfer of one board from the UIC conveyor to a DEk screen printer. They are set up for SMEMA to SMEMA but the DEK keeps asking for a aboard when it already has one. Then it will ask for one every 5-8 seconds. DO I have a
Electronics Forum | Fri Jul 08 13:43:20 EDT 2005 | pjc
I sell in-line ATE/ICT systems. They are designed to identify passed or failed boards coming off the tester(s). You can do so with a 90 deg. diverter and an extra magazine loader. The ICT machine knows which has passed and which has failed, so it com
Electronics Forum | Mon Jul 20 23:06:49 EDT 2009 | mika
10 or even up from a UIC conveyor of the old model - probably SMPI is the connector from UIC fully loaded, then full SMPI, but not all of them are used. Just Good board, bad Board, send, receive acknowledge. It is possible to convert this into SMEMA.
Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.
Electronics Forum | Thu May 02 13:40:25 EDT 2019 | youngbuck
Hello All, I am having a issue with Siplace 80 F5 with parts placing of in the X direction after I do Zero Point Correction with tool and Full Calibration. I also do the Gantry Zero Point correction and parts still place off in the X about .200mm to
| 1 |
