Electronics Forum | Thu May 18 13:00:27 EDT 2017 | stephendo
If the OEM is doing the installation then phone up the sales guy to touch base and find out what you have to have ready for when the tech shows up to install it. The sales person will want everything to go smoothly as much as you do. Play your cards
Electronics Forum | Thu Jun 07 10:03:19 EDT 2012 | anton99
Hello, I recently joined this site and this is my first post. After searching through the existing threads I decided to post my question. I work at a CCA manufacturing facility that recently added a SMT line. We used to have one line and now we are r
Electronics Forum | Thu May 18 07:37:06 EDT 2017 | stephendo
I have just been asked to project manage the > introduction of new production line within my > organisation . This normally wouldn't be a > problem but I have very little experience on smt > manufacturing. I guess the hard part is done as > all
Electronics Forum | Thu Jul 20 09:21:24 EDT 2006 | fabione
My actual line(europlacer928+europlacer400)(7500-10000c/h)it is too much slow in the change of production(3 change to day) My choice is mydata as principal line (hight changes low volume) and old europlacer for my 8 product with max volume. or Siemen
Electronics Forum | Wed Feb 27 08:31:02 EST 2013 | anton99
We are a OEM and growing pretty fast. The like the idea of setting up common components on the machine. It makes sense from a set up perspective. All of our set up is off line but the set up usually lasts longer than the SMT run so we have some spora
Electronics Forum | Tue Feb 07 10:18:34 EST 2017 | swag
Our entire shop floor has a hanging uni-strut grid ceiling approx. 10 feet up. The actual ceiling of the building is probably 16 ft. max ceiling with pitch. We run all air lines and power on it. The uni-strut is hung by all-thread rods. Sounds co
Electronics Forum | Wed May 31 20:47:29 EDT 2017 | juliefarrell
Anthony, I hope that your new production line has been running smoothly for you. I would like speak with you about who you are getting your bare PCB boards from. My company, ICAPE Group has 35 manufacturing partners in China. Full service provide
Electronics Forum | Wed Feb 22 20:11:59 EST 2006 | slthomas
*Qualify* your equipment by running X boards, Y times, through each piece of equipment under normal operating conditions and quantifying the performance, as in a ppm rating. Then validate your process by defining all of the steps you use to generate
Electronics Forum | Thu Feb 23 02:46:16 EST 2006 | INGE
It isn't an FDA validation. I think Steve has centered the problem. I have already defined all the steps and all the procedures of the process, but now I must run X boards, Y times, through each piece of equipment (as he said before); the question is
Electronics Forum | Thu Feb 23 10:49:38 EST 2006 | slthomas
Defining failure modes will help determine what you need to quantify in all processes. Personally I wouldn't pursue the DoE angle (varying setup parameters to determine robustness). 1)How about % pad coverage, paste thickness, and accuracy? Define w
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694
