Electronics Forum | Sun Sep 30 09:50:18 EDT 2012 | rgduval
We believe that Dave's analysis above is mostly accurate. Run a board with no components, and check for voids. We'd also like a little more information, though, to clarify. What type of component is experiencing the voiding? You describe the void
Electronics Forum | Tue Nov 20 15:32:12 EST 2012 | lace138
Hi Guys, I recently have moved my 2 smt lines (Assembleon) and need to make sure my compressed air quality does not have any oil and water. The specs in the manual state "water and oil free" compressed air which is very vague. Would anyone know wh
Electronics Forum | Tue Dec 04 15:01:02 EST 2012 | davef
Here, the aim of using protective gloves in the SMT assembly area is to keep solder paste from operator hands for safety reasons. And sure, you make a good point, while you're trying to determine the correct material, it's a good idea that these glov
Electronics Forum | Mon Jan 28 14:51:39 EST 2013 | jagriffin
I run have a small SMT line that we run small engineering samples runs on. I have a 625 pin BGA that has a metal top and I have never ran one like it before. I am not sure how it will react.... will it pull the heat up away from the PCB or just heat
Electronics Forum | Thu Feb 14 17:50:05 EST 2013 | jorge_quijano
I agree with Evitmov, I like to train the operator to do as much as possible, specially with the Changeovers, if they are responsible to load & adjust feeders, they will do it in the right way, if not it will be difficult for themselves to run the ma
Electronics Forum | Mon Apr 01 08:09:36 EDT 2013 | babe7362000
We currently have an AOI after reflow, and I was wondering how others have thier line setup? Does the AOI operator have to get up and get a board from the oven to run, or should the SMT operator hand the AOI operator a board. The AOI operator does
Electronics Forum | Wed May 15 12:53:19 EDT 2013 | mchawg
I am having difficulty programming/inspecting a large SMT Relay. It is a dual in-line through-hole package with 5 leads per side formed to a gullwing configuration on .100" pitch. We have programmed it as a SOW10 pkg and got usable lighting values bu
Electronics Forum | Mon Jun 10 13:31:29 EDT 2013 | emeto
Is there anything on the other side of the board? If not the process will be very standard. 1. SMT - place the small parts on your board. It is called surface mount technology. Basically one machine applies solder paste on the board, another machine
Electronics Forum | Mon Jul 22 10:37:06 EDT 2013 | torch
we have been asked by a client if we are capable of producing product that will require HMP, I am currently tyring to gather as much info as I can with regards to this solder type and would like help can we run this type of solder through a smt line
Electronics Forum | Wed Aug 06 11:16:20 EDT 2014 | clayton
While I have had very limited experience with mancorp, the experience I have had, has been less than satisfactory. However I do have a great deal of experience with Essemtec. I currently own two complete turnkey smt lines from Essemtec and couldn't
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694