Electronics Forum | Sat Jun 05 07:47:47 EDT 1999 | Dave F
| | | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks
Electronics Forum | Tue Jun 22 17:37:51 EDT 1999 | Dave F
| I was wondering if anybody could give an estimated cost of equipment maintenance per year for a complete SMT line for | a medium volume facility? | John: Budgeting for maintenance from two perspectives: 1 We budget 1 percent of the capital cos
Electronics Forum | Wed Oct 28 19:46:42 EST 1998 | Steve
I have worked on the 3AVX machine before. Please contact me via email. Steve | | I'm still looking at equipment to start an SMT line. It's a jungle out there!!!!! | | Does anyone know of/have experience with Contact Systems Inc.. Specifically the
Electronics Forum | Mon Apr 02 17:25:53 EDT 2012 | tombstonesmt
Just PM'd our Pillarhouse Jade Mark II this morning and found excessive solder balls all over the solder pot as well as the bottom of the machine. While removing all the dross it's very obvious that the dross is a REAL fine powder unlike any of the o
Electronics Forum | Wed Dec 09 07:14:16 EST 2020 | bukas
if you can set bad mark white=good on first machine, black=good on second machine and place same 3 components on them then all is left for 3rd machine not to look for bad mark but just to place remaining components. is board panelized? do some math a
Electronics Forum | Wed Nov 07 15:50:52 EST 2007 | Frank
For a modest invest of capitol equipment and maybe some hair pulling to learn the process it shouldn't be terribly difficult to get your own production line up and running. You just missed a few trade shows that you could have went to and seen all t
Electronics Forum | Tue Jul 26 13:04:02 EDT 2022 | kumarb
Hi. Sharing a new contact we have from a company in Shenzhen that has a focus on refurb machines that may be worth a quick call: www.qy-smt.com smtripathy[at]qy-smt.com They apparently setup up shops even on a rental basis! Unbelievable that they w
Electronics Forum | Mon Jun 07 13:51:48 EDT 1999 | Dave F
| | We are changing from through-hole to SMT, wondering what pitch requirements would an 8 pin SOAC require for pick and place? We think that this would be our finest pitch part. | | | | | | | John: Never heard of an "SOAC." SO packages are 50
Electronics Forum | Mon Jun 07 20:12:42 EDT 1999 | John Martell
Thanks for the advice, I'll check out that site. | | | We are changing from through-hole to SMT, wondering what pitch requirements would an 8 pin SOAC require for pick and place? We think that this would be our finest pitch part. | | | | | | | |
Electronics Forum | Mon Jun 17 17:02:38 EDT 2002 | kenbliss
Dave, in theory I agree with you, but in the real world isn't the expensive fruit, the fruit you spend countless hours trying to fix a small defect that has a fixed cost, the cost of the board as a single unit. Versus the cost of running the factory
DONGGUAN KINGSUN AUTOMATION TECHNOLOGY CO.,LTD is a company which mainly provide used and new SMT parts, provide repair SMT key parts service,new/used SMT machine trading,SMT consumables and Peripherals equipment,Clean room, ESD..
3th, Tangchang 3rd Road, Hengli, Dongguan City
Dongguan, China
Phone: 8615629932323