Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Mon May 04 16:34:13 EDT 1998 | Denis Desrochers, Manufacturing Engineer
We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line.
Electronics Forum | Mon Jul 20 10:23:29 EDT 1998 | Sherry
Hello friends.... Can someone please point me in the right direction... I will be needing the capability of forming/trimming QFP's on a very low volumn scale in house. So far I've only been able to find one manufacturer and that is Fancort Industri
Electronics Forum | Mon Jul 20 13:28:14 EDT 1998 | Chris Fontaine
We regularly form QFP's and FP's (pitches to 20 mil) and have experience with both Knight and Fancort equipment, however most of our experience has been with Knight. Knight Tool has been consistently good, and I've had some sour experiences with Fan
Electronics Forum | Fri May 22 15:39:59 EDT 1998 | serge
good morning sir i m Belgium and i was responsable for SMT training and maintenance for Alcatel do you believe that i can help you??? | We are just starting out with SMT. I need any and all the information you have. We are looking to start a sma
Electronics Forum | Fri May 15 09:09:50 EDT 1998 | Earl Moon
| We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line. I provide consultation for these requirements. Please contact if interested. Sincerely, Earl Moon pod@ix.netcom.com
Electronics Forum | Mon May 04 21:35:25 EDT 1998 | Dave F
| We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line. Denis, You should pursue the following SMTNet thread on this topic: Posted by Igor Kostyuk on April 22, 1998 at 16:57
Electronics Forum | Wed May 06 10:20:21 EDT 1998 | SMT-ASSY
Good morning, We would like to offer our services. SMT-ASSY is a training facility (Located in Dorval, Montreal area) which can introduce your workforce to SMT and the workmanship required to obtain quality products. We have attached our brochure in
Electronics Forum | Sat May 09 12:01:51 EDT 1998 | Bob Willis
If you need some training materials have a look at my Internet Web Page www.bobwillis.co.uk I have the second largest video list on electronic assembly second only to IPC. I have the largest range of CD ROM and Poster sets which may be of interest. M
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
