Electronics Forum | Fri Mar 26 17:12:17 EST 2004 | ben
I have recently encountered a new pcb design with a very high density of components on either side of the pcb. One of the suggested "fixes" is to use the smt pads as vias i.e. the via will be drilled thorough the centre of the smt pad. My concern i
Electronics Forum | Tue Oct 17 12:07:58 EDT 2006 | pms
ya don't need no stinkin pads. just run sum fine gauge insulated jumpah wires from da I.C. legs (da ones with da missin pads) to da traces or where-ever dem traces end up. dat should get er dun !!!!
Electronics Forum | Sat Apr 03 05:21:33 EST 2004 | mattkehoe
There is a method for VIP you may not be familiar with. I dont want to go into depth here but check out http://www.sipad.com/sipadvip.htm and contact me off line if you want more info. Good luck. mk
Electronics Forum | Sat Mar 27 08:15:02 EST 2004 | davef
Via in pad is a designer's dream and an assembler's nightmare. Search the fine SMTnet Archives for previous discussions to get started. VIP, via-in-pad, or whatever tend to promote voiding within the via and certainly partially starved solder conne
Electronics Forum | Wed Oct 18 07:51:14 EDT 2006 | davef
Look here: http://www.circuittechctr.com/ As a low cost approach, use copper foil purchased from a stained glass window hobbyist shop. Cut foil pieces to size with a sharp knife. Epoxy the pieces in place of the damaged pads. Tin and then solder th
Electronics Forum | Mon Oct 16 17:46:49 EDT 2006 | Dan
Recently I was given a bad Bios Link from Toshiba which fried my Bios and now my laptop boots to a black screen. I recently unsoldered and removed the existing Bios chip and have ordered anotherfor replacement. Unfortunately while removing, i damag
Electronics Forum | Fri May 06 08:39:59 EDT 2016 | kahrpr
The first issue I see is that you have a high potential of the 402 tombstoning.
Electronics Forum | Fri May 06 08:47:05 EDT 2016 | davef
You're correct. This design will have a record amount of 0402 rework for tombstoning and misalignments. Suggest that the pads on each end of all components be the same size in order to balance wetting forces during reflow.
Electronics Forum | Fri May 06 06:51:55 EDT 2016 | abhilash4788
Hi All, One of my customer has provided a pcb design having common pad for 0402 and 1206 package(i.e 3 pads in the gerber, pad1,pad2 belongs to 1206 package and pad2,pad3 belongs to 0402 package) Will this create any solderability issue. Is anyone e
Electronics Forum | Mon May 09 09:23:45 EDT 2016 | markhoch
I agree with the previous two replies. This is a perfect design....if you're trying to create a graveyard full of tombstones.
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang, Fuhai Street,Fuyong
Shenzhen, 30 China
Phone: 13713862102