Electronics Forum | Wed Dec 20 09:41:52 EST 2000 | blnorman
Ideally we want to mix the same lot numbers in a repackaged tube. Once again, these are partial tubes that have been thrown away. If the ratio is right to begin with the only change would be due to air exposure. Semco makes a TC seal which, if we
Electronics Forum | Fri Apr 06 08:35:20 EDT 2001 | brownsj
You can buy plenty of paste height measuring systems today, ranging from full 3D laser systems to systems using an oblique light line which will measure the paste height only. I found that the lowest cost option was to attach a DTI to the focus contr
Electronics Forum | Tue Dec 15 15:21:24 EST 1998 | Chrys
| SMTneters, | I'm famialiar with lambda, omega, and gemini waves but not with "A" wave. Can somebody give me an explanation? | | thanks | | Tom B. | Tom, The term "A" wave refers to an asymetrical wave. It's an Electrovert term that describes
Electronics Forum | Mon Nov 02 09:44:21 EST 1998 | Michael Nguyen
Well my process is I'm running my belt speed at 3.50fpm and about 215 to 225 degrees top side. I got my main wave down to a little less than half the board thickness. I'm not using a hot air knife cause we thought it might create more of a problem th
Electronics Forum | Thu Sep 06 10:58:49 EDT 2001 | davef
If your words imaged correctly, it seems a bit strange to have a trace that is wider than the pad where it connects, because we�re used to seeing a narrower trace connecting to a wider pad. It�s tough to determine what the designer was thinking abou
Electronics Forum | Tue Dec 11 13:56:38 EST 2001 | Damian Holzmann
Regarding your comment "technology doesn't seem to have improved". Actually, technology has improved significanty. Cyber Optics uses a line measurement, a new unit from Germany uses sine wave differential measurement. The Gridmeter unit captures a vi
Electronics Forum | Mon May 27 18:51:17 EDT 2002 | harotec
Hi Yngwie Have you got a reflow oven yet. If not, forget about complicated profiling with test runs or reflow trackers. We've got a nice oven with integrated temperature-feedback system. You build any profile you want and the oven will adjust its hea
Electronics Forum | Fri May 07 12:39:01 EDT 2004 | rontdc
Bruce, Using a foam fluxer with no-clean flux is a very touchy situation. It is imperative that the specific gravity of any flux be maintained within the manufacturers recommendations. If it is not, you will get icicles and bridging. Maintaining the
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Wed May 04 11:54:29 EDT 2005 | HOSS
Rob, Are you hinting that the lead content of this component with dipped tin/lead solder would not be an issue with RoHS? If so, our understanding is that the legislation requires that the 6 banned substances cannot exist at greater than X% in any