Electronics Forum | Thu Oct 12 22:36:40 EDT 2017 | stefan110882
Please ost some pictures so we can see what > you're talking about. OK here an example. I'm sorry for the bad quality - The picture is cropped and only one of two pictures that I had on the phone that I could use. According to my supervisor, th
Electronics Forum | Mon Dec 04 08:43:39 EST 2017 | bandjwet
If you are looking to rework (after all of the previous suggestions are taken and tried....you have some solid ones in there). When a device like this is placed and is hard to get to we use the 7721 bumping process using a controlled heat source (no
Electronics Forum | Wed Jan 17 05:58:45 EST 2018 | awelektronik
Hi Evtimov, no, i have no possibilities to change the Light. My Camera knows only on and off. The PCB-Solder resist looks in that IR-Light whyte like the CE-Symbol of the picture i post in my first message. The Pins with gold looks the same. Its an
Electronics Forum | Mon Apr 09 14:51:04 EDT 2018 | justconmac
UPDATE The reason for the board count in the wave when there are no boards is due to operators leaving racks with empty PCB slots. The input feed sensor is a little bit more in the center of the conveyor whereas the output feed is a slightly closer t
Electronics Forum | Fri Jan 11 02:19:54 EST 2019 | jlawson
Jetting paste is no easy , ball mesh size and metal loading, SG and the dynamic rehology of the flux medium need to be matched to the jetting forces from the dispensing system. There are many jetting valve makers Musashi from Japan, Nordson Lyquidyn
Electronics Forum | Thu Sep 13 13:04:52 EDT 2018 | jrs192
Hello! Recently started buying PCBs with peelable mask to remove the need for Kapton tape. Had no issues with our first batch, but our supplier has over-cured the second batch - it comes off in tiny bits, and is stuck in the holes. After timing the
Electronics Forum | Fri Jan 04 22:23:23 EST 2019 | ameenullakhan
Hi, Here we take profile for every changeover. And we compare it with our profile.For the oven performance. We daily take a minimum of 3 profile for one oven. We have High mix low volume production. We are using ORH1 ( organic flux with halid cont
Electronics Forum | Fri Jun 07 11:19:14 EDT 2019 | gregoryyork
If you have soldered with HASL finish then the worrying chemistry will be more like NON IONIC. They sit there and attract moisture like mad and any chlorides they hold ionize in the moisture attracted and cause electromigration or SIR issues. They ca
Electronics Forum | Tue Jun 11 11:22:19 EDT 2019 | sumote
If the board is just not reaching the temps you need, you could place them in an oven to "preheat" them. When I was building a rather thick board with a copper core I had to do this. Since we were only doing small runs it was feasible, I don't know y
Electronics Forum | Thu Jul 25 07:50:37 EDT 2019 | jmedernach
Hi Folks, It's been a coon's age since I've been on here. I'm wondering if the community can't help me out with something. "Back in the day" there were thermocouples made by Saunders, Temprobes, with a design that would clamp on the board edge. Yo