Electronics Forum | Fri Apr 27 09:43:04 EDT 2012 | capse
I have worked with Chrys Shea for a number of years. She has written a few white papers on SPI that may be beneficial to you. Here is a link to her website; http://sheaengineeringservices.design.officelive.com/default.aspx
Electronics Forum | Tue May 29 07:06:03 EDT 2012 | aj
spacing is very tight but you should be able to get it right... If possible try and run it at 45 degrees over the wave and see how you get on... we had a similar problem and this improved things dramatically ( but we had a selective pallet that wa
Electronics Forum | Fri Nov 02 14:10:41 EDT 2012 | kahrpr
The versa flow is defiantly a better machine. However its not a fair comparison the versa flow costs about 4 times the cost of the ace. For the money the Ace is a good machine.
Electronics Forum | Mon Apr 04 14:26:14 EDT 2016 | tombstonesmt
That is amazing nozzle life. One thing you did not mention is the amount of usage. We have a product we run two shifts, 6 days a week; we typically get a month out of one nozzle. We make our own in house.
Electronics Forum | Mon Oct 08 14:52:13 EDT 2018 | emeto
+paste was not stored properly Paste doesn't have enough flux and is more sticky than usual. Could be a lot code related or a purchase order related. I wold order a new jar and try immediately.
Electronics Forum | Wed Dec 11 07:58:38 EST 2019 | clockwatcher
Although this is not technically a bottom termination component, the method of attachment of the thermal pad is a bottom termination attachment. For bottom termination components IPC states that "thermal pad void criteria shall be established between
Electronics Forum | Wed Sep 08 11:33:12 EDT 2021 | stephendo
Strange finish on the pads? So no solder left on the pad? Pad on the board or pad on the part? Does the jig go through the oven with the board? If so I would recommend sacrificing a board and drilling a hole in the bottom to have a thermocouple at th
Electronics Forum | Thu Dec 02 17:57:54 EST 2021 | swilson
Hello I have a situation here. I am wanting to get wave pallet, but I have a TH component that is too close to the SMT pads looking at @.020" it should be .100" min. If I get a pallet will it not wet that TH component or will it work? Any R
Electronics Forum | Wed Feb 02 21:32:13 EST 2022 | chuckphd53
The rotation is a fixed parameter..... and of the 9 parts, randomly it will skew the part, could be one or more... I was thinking maybe the solder paste was too dry and during the LIFT after placement it would blow the part sideways.. Yes I am on a
Electronics Forum | Tue Jul 19 13:58:38 EDT 2022 | proceng1
PRocedure is attached to post. I had calibration jigs made, but you can use a glass plate with a crosshair, or a hole in the board.
