Electronics Forum | Wed Apr 03 04:54:46 EDT 2013 | ericrr
Thank you for that, I see the #106 nozzle looks in better shape (with the rubber) I might try that nozzle and see how it goes on a few boards, then I could let the "higher authority" know.
Electronics Forum | Mon May 06 07:22:23 EDT 2013 | cbeneat
Do you have the splice manual? I can email you a copy, send your email address to me I will send it out.
Electronics Forum | Mon May 06 09:01:08 EDT 2013 | mbb
Yes, we have manual splice either with a joint tape or with both clips and joint tape . Please, If you have any suggestions, email me on: mariem.khlifi@ymail.com
Electronics Forum | Thu Aug 28 02:51:01 EDT 2014 | padawanlinuxero
When you say "selecting correct value of the small chip components during assembly", you are referring to caps and resistors? and that you want to know that the correct cap or resistor was place in the correct location? your assembly is surface moun
Electronics Forum | Mon Sep 08 10:03:51 EDT 2014 | gregp
We have a solution for the through hole portion of your requirement. You can contact me directly at sales@versatecsolutions.com Regards, Greg Pompea Versatec
Electronics Forum | Mon Aug 22 12:25:15 EDT 2016 | mosborne
Ours does the same thing. I was told to update the software to fix the problem, but we just upgraded to a new machine.
Electronics Forum | Sun Sep 25 14:26:41 EDT 2016 | mrpackethead
Im looking for manuals for theYV100-2 and YVL88 machines, as i have just bought a 2nd land line at auction. Does anyone have one, or know where i can get one from?
Electronics Forum | Sun Oct 09 16:57:30 EDT 2016 | davef
IPC 2222A Sectional Design Standard for Rigid Organic Printed Boards, 5.3 Design Requirements for Printed Board Assembly
Electronics Forum | Thu Dec 08 22:57:45 EST 2016 | ttheis
I'm not too experienced with this but what about an air-blast with an ionized air source such as an air knife above and below a conveyor to push most of the fluid off of the pcba then run through an oven just above vaporization temperature.
Electronics Forum | Tue Jul 25 13:14:31 EDT 2017 | ks0707
Hello Evtimov, Thank you for your advice. Each job/customer has different and most of them don't supply AVLs. So you mean that there is no way to make programming easier. right ? Have a good one. John