Electronics Forum | Fri Jul 29 16:20:57 EDT 2016 | davef
"ALPHA® EF-2210 is VOC-free, halide-free, rosin/resin-free, low solids no-clean flux which provides the highest activity of any VOC-free Bellcore SIR compliant flux for defect-free soldering. "[2016 Alpha Assembly Solutions] I assume that you're tal
Electronics Forum | Thu Jun 24 11:44:20 EDT 1999 | Matt Stump
I am looking for a way to clean solder off of QFP packages. I'm thinking a chemical method would be easy, as long as the chemistry doesn't attack the leads themselves, or the package. Any suggestions?
Electronics Forum | Fri May 26 10:03:13 EDT 2006 | smteng0201
We heard about the Saki systems and did not receive positive feedback. They are quite fast but they miss a lot of easy defects; especially solder ones. Have you checked out a Mirtec system yet?
Electronics Forum | Tue Feb 07 13:01:52 EST 2006 | amol_kane
Hi, does anyone have any experience with common wave soldering defects using SAC305 alloy?.....i am finding a lot of what seem to be shrinkage cracks on the bottom side surface of the soldered components.....there is also a lot of directional cooling
Electronics Forum | Tue May 30 21:14:31 EDT 2000 | Dave F
Sal: JAX makes good points, but I�d like to think about this differently. It sounds like the poorly soldered connection is lifting the whole connector, so that termination floats on top of the solder, rather than submit to the wetting force and be
Electronics Forum | Fri Dec 19 10:18:05 EST 2008 | dyoungquist
On TH parts we have been hand soldering. This last summer we purchased a Rhythm selective solder machine from RPS automation. I did a factory tour of both RPS and ACE since both facilities are about 1/2 mile from each other. In comparing the 2 c
Electronics Forum | Fri Dec 31 10:16:22 EST 2004 | Brad
Can anyone recommend a company thats local to New England that does extensive solder joint analysis.
Electronics Forum | Tue May 29 10:08:17 EDT 2007 | aj
Hi Dave, The customer is supplying a new batch as this batch just doesnt want to solder. aj...
Electronics Forum | Wed Dec 08 17:58:44 EST 1999 | Dave F
Dave: You should see a solder smudge on the gold plating where the ball was attached, if there is (was) solder reflow during either the (1) BGA fabrication, (2) your BGA attach, and / or (3) your BGA removal. You rework will not remove the solder
Electronics Forum | Fri Dec 15 14:22:22 EST 2006 | realchunks
Sure. Treat it like wave solder. Top side wetting is generaly harder to achieve than wave so don't over look it. On most selective solder machine, the delta-T is also something to look out for. Most move from preheat to pot. And snce the pot por