Electronics Forum | Thu Jul 20 17:10:11 EDT 2000 | Darby
It's six in the morning here! Give me a bell the next time you are out here and I'll take you fishing on the sensational Sydney Harbour. However I will not be getting out of the boat and "diving" - too many noahs arks. I'll leave that to the daredevi
Electronics Forum | Wed Mar 24 08:36:58 EST 2004 | Evtimov
Hi! What exatly you do? Do you reflow the both sides of the board at the same time or you reflow your second side? I think in both cases you should decrease you bottom zones. If you reflow both sides - with 10-20C(F) If you reflow the second side - w
Electronics Forum | Sun Nov 22 19:59:26 EST 2009 | prodivegsr
Hi Davef, The bubbles occurs at the body also...there's also a washing process before the conformal coating:-the Flux residue are removed after washing. ... The curing profile is also something that we are looking into during the initial troubles
Electronics Forum | Sun Nov 29 20:04:05 EST 2009 | prodivegsr
Hi sforman1, The chemical that i'm using is a solvent based coating humiseal 1B73. From my understanding,the UV curing is mainly for UV curable coating like the UV40. And the main advantage of using UV curing is for fast throughput and environment
Electronics Forum | Mon Nov 30 09:05:47 EST 2009 | sforman1
totally wrong. a. I do not reccomend Humiseal UV products. My Dad started Humiseal. b. As the former VP of Dymax Corporation I know quite a bit about this subject. Contact Dymax in Torrington, CT and inquire about 984LV. c. You will definetly sleep b
Electronics Forum | Wed Dec 02 00:31:37 EST 2009 | jlawson
UV40 for you info was developed in Humiseal EU and has been tested heavily against Dymax product. UV40 is a great product has many approvals from major auto and whitegoods makers.... I have seen comparisons UV40 to Dymax 984LV and Dymax comes out se
Electronics Forum | Thu Feb 02 08:54:43 EST 2017 | emeto
Hello all, I was just wondering if solder pot temperature affects the quality or the life of the solder joints? For example we run 100Sn at 275C. If I bump it up to 300C, what is that going to change?
Electronics Forum | Tue Mar 21 12:52:56 EDT 2017 | emeto
No clean is giving us problem in ICT. Other than that, a coating of flux should remain there to pretect the solder joint from the environment. In general you should not clean NO clean - it is supposed to be there.
Electronics Forum | Mon Apr 17 19:42:34 EDT 2000 | Russ Cutler
We just bought a new Heller 1800 EXL reflow oven for reflowing SMT boards. We us a low temp RMA solder paste with 2% silver. Everything we build is to IPC Class 3 specifications. We have approximately 600 different types of circuit boards we build
Electronics Forum | Fri Jul 16 05:24:40 EDT 1999 | Chris May
| I'm looking into vision inspection equipment to automatically inspect SMD placement and solder joint quality. Does anyone have any recommendations or know of any commonly used equipment? Do other manufacturers use vision systems at their inspecti