Electronics Forum | Thu Jun 29 14:29:25 EDT 2000 | Glenn Robertson
Leon - Remember for a CBGA you will need to use high-temp solder balls. IBM can supply the recommended solder paste (eutectic) volume. Glenn Robertson
Electronics Forum | Thu Mar 22 16:06:22 EST 2001 | dblsixes
Our next plan of attack is to dog-bone the solder aperature. By reducing the width of the solder paste at the heel, we hope to slow the flow up the leg of the pin while the temperature of the pad catches up. We have boards that were HASL ...
Electronics Forum | Thu Apr 12 22:35:42 EDT 2001 | davef
Consider the profile recommended by your solder paste manufacturer to be the starting point to begin tailoring ramp rate, dwell times, and temperature excursions to meet the requirements of your boad design, the capabilities of your components, and t
Electronics Forum | Tue Aug 22 11:29:45 EDT 2000 | �ngelo Marques
Hello, Dr. Ning-Cheng Lee The melting point of solder PB-Free its to higher do you now the lower temperature of an PB-Free and its constitution. Its true if the solder paste have in its constitution a Bismut component the melting point its lower?
Electronics Forum | Thu Jul 20 14:16:39 EDT 2000 | Jeanette
Is the temperature the only drawback when reflowing components other than connectors? for example caps, transformers. Is there a problem with the soldering quality if the body of the component covers the solder paste?
Electronics Forum | Tue Nov 23 20:05:05 EST 1999 | Jeff Ferry
Ted, We've tried using dispensing systems but without success. We either use stencils or bump the pads with solder. Stencils are messy and time consuming, but seem to be the best thing going. Jeff Ferry Circuit Technology Center
Electronics Forum | Tue Oct 26 13:57:34 EDT 1999 | Dave F
Joe: Both dpmo and measuring solder paste height are good topics to practice your SMTnet archive searching skills. Yes, some microscopes can be used to measure solder height. Good luck Dave F
Electronics Forum | Fri Jul 17 15:29:54 EDT 1998 | Sandro R. dos Prazeres
Is there anybody with knowledge in the process with PHT components (Components with terminals) - Cause with make board with top and bottom side, with SMD and Auto Insertion Technology. So we want to do a Entire Cell with both technology, and without
Electronics Forum | Fri Jul 31 10:51:15 EDT 1998 | Jim McLenaghan
| Is there anybody with knowledge in the process with PHT components (Components with terminals) - Cause with make board with top and bottom side, with SMD and Auto Insertion Technology. So we want to do a Entire Cell with both technology, and witho
Electronics Forum | Fri Jul 17 21:50:23 EDT 1998 | Sergio Corcuera
| Is there anybody with knowledge in the process with PHT components (Components with terminals) - Cause with make board with top and bottom side, with SMD and Auto Insertion Technology. So we want to do a Entire Cell with both technology, and witho