Electronics Forum | Mon Jul 26 17:57:50 EDT 2021 | cyber_wolf
Place a label and etch that instead of the PCB. Too many variances in solder mask
Electronics Forum | Fri May 27 18:43:19 EDT 2022 | SMTA-64387182
Thanks for confirming. Joe
Electronics Forum | Tue Nov 22 02:38:30 EST 2022 | davef
What type of material is your solder mask?
Electronics Forum | Tue Oct 03 18:11:58 EDT 2023 | glasscake
Scalpel, audio book or a podcast. if you have a micro bead blaster that would be faster
Electronics Forum | Fri Apr 12 17:22:47 EDT 2002 | davef
First, splitting hairs on parlance. * Conformal Coating. A thin electrically nonconductive protective coating that conforms to the configuration of the covered assembly to provide environmental and mechanical protection. * Solder Mask. Coating mate
Electronics Forum | Tue Dec 14 11:17:45 EST 1999 | John Thorup
Hello Mike You'll have to be a bit more specific. Do you mean permanent solder mask like the normally green material or a temporary mask like the peelable/washable material? John Thorup
Electronics Forum | Fri May 28 15:50:48 EDT 1999 | Frank Boyko
We now put soldermask on copper and then immersion nickel/gold plate our fine line boards. One of our vendors says this causes skipped plating in small via holes and wants to nickel/gold plate the whole board, including via holes, and then apply sold
Electronics Forum | Wed Dec 18 08:19:00 EST 2002 | cyber_wolf
One thing that will also cause this is very slight stencil mis-alignment. Sometimes the paste will have a tendency to hang up in the apertures if you are over hanging just a little on the solder mask. Some solder mask are very slick and will not pull
Electronics Forum | Tue Mar 30 02:58:55 EST 2004 | Grant Petty
Hi, Thanks for the ideas. With the solder mask curing problems, can you normally wipe off the white residue, as we can do this on our boards with our fingers. It's almost like the surface of the board has a "wet dried up" look to it, and it's a smok
Electronics Forum | Mon Mar 07 11:20:10 EST 2005 | mrduckmann2000
Russ, I tried to get a screen for glue but the design engineer who laid this board out made up his own rules. The 0402 pads are to close for a proper dot size.....per the stencil house. That is why I am going the solder mask route. I would rather