Electronics Forum | Fri Nov 30 14:27:58 EST 2012 | ericrr
I take that as a no, you have lost me
Electronics Forum | Wed Apr 03 04:14:10 EDT 2013 | sdhmuni12
Thank you
Electronics Forum | Sun Jul 28 05:35:25 EDT 2013 | mbb
Is it possible to run Pb-Free reflow without nitrogen?
Electronics Forum | Wed Dec 09 10:45:56 EST 2015 | huske
I've put down a SOT223, close enough to your 3pin transistor, in the same situation you have. The large pin was to be soldered on a large exposed ground plane in the corner of a board, over 2"x2" exposed area. We left the paste file as is, so where
Electronics Forum | Mon Sep 19 09:31:28 EDT 2016 | emeto
Whatever the cause is, will be fixed by applying less paste. So Homeplate it is.
Electronics Forum | Fri Mar 24 03:19:17 EDT 2017 | Rob
Thanks Charlie & Jerry, subtlety is not something I have ever been accused of in the past.
Electronics Forum | Tue Jul 04 09:55:40 EDT 2017 | spoiltforchoice
Does the manufacturer even supply those outside Asia?
Electronics Forum | Mon Jul 10 02:34:10 EDT 2017 | sachinverma
no
Electronics Forum | Thu May 17 17:39:46 EDT 2018 | dleeper
You could use this: https://plastidip.com/our-products/plasti-dip/
Electronics Forum | Sun Sep 09 08:38:14 EDT 2018 | devinpcb
I have found the paste flux is the worst. It leaves a black residue that can corrode.
Capital Equipment Solutions - SMT | PCBA | TEST
Equipment Dealer / Broker / Auctions
113 S Main Street
Lodi, USA
Phone: 6083431779
