Electronics Forum | Thu May 30 09:33:15 EDT 2019 | emeto
Contributors in order of importance: 1. PCB design - if you have large thermal pads, a grid of via holes should be created. Components with low profile will not let the gas to escape from the joint. The only way is going down. 2. Reduce paste volum
Electronics Forum | Mon May 06 11:45:32 EDT 2019 | slthomas
There are quite a few papers out there on the subject. Just enter "SMT void reduction" into google or other search engine and take your pick. That said, slow ramp rates and paste volume reduction are a good place to start. Although I haven't tried i
Electronics Forum | Sun Nov 14 20:33:39 EST 2010 | isd_jwendell
Hopefully you have a dispenser on your machine so that you can add a few large dots of paste to the thermal pad.
Electronics Forum | Thu Sep 27 15:16:34 EDT 2007 | novaman
Hi everybody, I did post in the past last year and I always got good answers. If I'm going to solder something with Tin-Lead solder and then put it outside (it will be exposed to water, sun, cold nights,...), how long does it take starting to rust?
Electronics Forum | Tue Oct 06 15:01:33 EDT 2020 | charliedci
We've used glass (pyrex, corningware) bread pans in the past, not filling them much over 1" deep. It takes a while but leaves solder ingots sized well to drop back in. Have not tried lead free yet, the higher temp could be an issue using same ty
Electronics Forum | Wed Nov 17 11:20:23 EST 1999 | Dave F
Hey Gyver: If you don�t mind (which you don�t have any choice about, because I�m going to do it anyhow, cause it�s MY word processor), I�m going to respond genericly, but still be directed to your question. Much of the following is paraphrased from
Electronics Forum | Thu Dec 08 22:56:07 EST 2005 | davef
Questions are: * Is the stencil design proper to provide the correct amount of solder paste? * Is the stencil design proper to provide for release of solder paste? * Is solder paste filling the stencil aperatures, prior to separation? * Are stencil a
Electronics Forum | Tue Mar 01 16:20:41 EST 2005 | lyrtech
Hi, Actually, we want to run a benchtest for solder paste to verify if the paste we use is one of the best. So, with your experiments and tests, what's the top 5 for No-clean solder paste? * I mean leaded solder paste ( for the moment) :)
Electronics Forum | Fri Mar 08 03:21:18 EST 2013 | sdhmuni12
Can a ROHS PCB with ROHS solder paste can be cleaned in same basin/sink when Non-ROHS solder paste PCB are cleaned? Any detail procedure or cleaning technics for NON ROHS Solder Paste PCB VS ROHS Solder based PCB?
Electronics Forum | Sun Aug 25 07:15:55 EDT 2002 | cnoonan
What are the industry standards for eutectic solder-paste in conjunction with the life span of solder-paste. What is the recommended duration of solder-paste on a printed circuit board. Example: You print a board, how long can it sit before runnin