Electronics Forum | Thu Mar 16 19:12:22 EDT 2017 | pzappella
Hi Rob, Thanks for the LED paper. I like the void area equations but I am puzzled, the paper did not say if the solder was a solder paste that would generate a lot of voids, or a fluxless preform or sinter material. The measured voiding level
Electronics Forum | Wed Nov 04 17:18:30 EST 2009 | davef
It will be very difficult to apply the proper amount of solder with a stencil to bump a ball that is the proper size. A low volume ball is less reliable than a customary sized ball. There are: * Reballing service providers * Reballing preforms * For
Electronics Forum | Fri Apr 15 13:46:50 EDT 2005 | steve
They can be expensive and if your using water soluble chemistry you will have to immerse the pre-form into flux. Asking the vendor to provide flux with the pre-form I believe it would dry out prior to use.
Electronics Forum | Tue Jul 16 01:28:48 EDT 2002 | ppcbs
Our BGA Rework process has resulted in 100% yield. We always bake BGA chips at 125 degrees C for at least 8 hours before installation. We always bake loaded boards at 90 degrees C for at least 12 hours before BGA removal. Any parts that went throug
Electronics Forum | Thu Sep 17 07:06:15 EDT 1998 | joakim fagerlund
We have problems with voids when we solder lids to ceramic flatpackages. The sealring of the package is gold(100 micro inches or 2.5 micro meters)with a underlayer of Nickel The solder is attached to the lid (preform) and the solder material is Au/S
Electronics Forum | Sat Mar 26 08:30:01 EST 2005 | davef
Consider this: * SolderQuick Winslow Automation-type [ http://www.winslowautomation.com ] preform * When LGA first came on the scene, we didn't have a clue. After trying sockets, we printed paste on the pads bug-up, reflowed, and then the placed the
Electronics Forum | Thu Apr 28 08:29:22 EDT 2005 | andymackie
If what you are talking about is "assembly materials", then consider the following: - Solder paste - Wavesoldering fluxes - Bar (for filling wavesolder pots) - Underfill (for TCE-mismatched CSP's and flip-chip) - Cleaning fluids (for post-reflow boa
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Fri Mar 06 15:04:11 EST 1998 | Todd N
| We have a double sided pcb that is surface mount on both sides. Now a Through Hole connector has been added. Appart from hand soldering does anyone have info. on reflow soldering the part. The connector is 0.1mm pitch, square legs. | 1) Do you need
Electronics Forum | Fri Mar 06 23:02:43 EST 1998 | Scott McKee
| | We have a double sided pcb that is surface mount on both sides. Now a Through Hole connector has been added. Appart from hand soldering does anyone have info. on reflow soldering the part. The connector is 0.1mm pitch, square legs. | | 1) Do you
