Electronics Forum | Sun Apr 25 17:30:25 EDT 1999 | Mohammad Yunus
| | | | We are just starting to manufacture a PCB with a .039" fine-line PBGA. We are currently seeing voids, mainly in the center, that are as much as 45%. We also intermittently see the corner balls of the PBGA smaller than the center balls. We are
Electronics Forum | Sat Feb 12 10:15:40 EST 2000 | Rick Thompson
I have to agree with Michael's comments. We've been evaluating systems for a month or so. There's a pretty wide range depending on what you're looking for. I'd say the first thing needed is to define your expectations. Are you looking for solder in
Electronics Forum | Thu Jun 03 15:19:14 EDT 1999 | Earl Moon
| | | In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We
Electronics Forum | Wed Jan 17 03:35:07 EST 2001 | Arul
We have few failures similar to the discussion in this thread, on a 50 Mil pitch, 30 Mil mill Ball PBGA. Would like to understand the mechanism of the BGA reflow process bit more. Appreciate your response to the following. 1.We sheared few solder ba
Electronics Forum | Fri Nov 13 09:55:08 EST 1998 | Chrys
| We are experiencing 'lifting' on one or more sides of a QFP. Poor lead co-planarity has been ruled out by independent tests. Please tell me which of the two remaining failure modes is the most probrable? | | 1. Expansion of gases in vias underneat
Electronics Forum | Thu Oct 08 03:27:00 EDT 1998 | Thomas Blesinger
| | | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the rema
Electronics Forum | Thu Oct 08 22:32:58 EDT 1998 | Dave F
| | | | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the re
Electronics Forum | Wed Jun 03 18:22:19 EDT 1998 | Chrys
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Wed Jun 03 21:40:38 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Wed Jun 03 14:17:12 EDT 1998 | Earl Moon
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
