Electronics Forum | Tue Dec 13 07:01:56 EST 2005 | clampron
Good Morning, We are currently using 4 Mirtec machines. We decided on the Mirtec after a side by side evaluation of several tabletop machines. I have to admit that Yestech was not one of them. However, after the evaluation, the Mirtec outperformed t
Electronics Forum | Wed Sep 17 13:00:25 EDT 2008 | mw_fl
For the most part there would not be a lot of change over. There are two primary boards at this time that would be run on the line that also use common components. At this point all but a couple of the pick and place machines we have looked at have t
Electronics Forum | Sun Oct 26 09:05:09 EDT 2008 | tony_d
Hello INGE FI, I know what you are going through. A few years back, I was faced with having to purchase AOI equipment for my business. My selection team and I looked at several different AOI manufacturers. We found that only two AOI vendors were sui
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Fri Feb 15 13:24:44 EST 2002 | Mike Konrad
Hi Dave, To close-loop or not to close-loop, that is the question� I can not speak for all machines, but in our case, close-loop systems are actually less costly to operate than open-loop systems (we make both). First, determine the volume of wate
Electronics Forum | Tue Sep 01 10:39:30 EDT 1998 | Mike
| | | We are experiencing shorting on a BGA. The part has a 1mm pitch with a 196 I/O count. The problem seems to pop up without warning & disappear in the same manner. | | | Our pad design is .020" diameter pads with .025" solder resist diameter.
Electronics Forum | Fri Jan 24 09:52:08 EST 2014 | davem
Hi Guys, So I work for a small contract manufacturer which caters mainly to the defense sector. As such, our customers haven't (yet) had a great need to incorporate 01005's into their designs. Looking forward, we decided to "take the plunge" and dia
Electronics Forum | Mon Mar 07 09:23:25 EST 2016 | rgduval
We've had our My500 for about four months now, and couldn't be happier. We are a super-high-mix, super-low-volume shop, and the flexibility provided by the 500 over stencils is stunning. So, you buy 5-10 stencils a week? That's 260-520 stencils a
Electronics Forum | Sun Feb 05 17:44:47 EST 2017 | spoiltforchoice
Printer->Paste Inspection(which might be a feature of the printer)->High speed placer (for all the little parts)->Accurate Placer(for your BGA Processor,RAM,eMMC and big things that don't fit in the high speed)->Reflow oven->AOI->PCB stacker All of t
Electronics Forum | Thu Apr 27 08:42:22 EDT 2017 | pvasquez
Hello M. We are a low volume high mix manufacturer with a total of 7 Mirtec AOI machines including a new MV-6 OMNI 3D system. I am very pleased with this machine! When we did our 3D AOI research, my team narrowed the field down to 2 vendors, Mirt