Electronics Forum | Wed Jul 14 13:41:40 EDT 2010 | rway
We are running SMT products and have been for some time now. First, I wanted to check with you folks to see what an acceptable FPY rate, or what you would consider and acceptable rate, is. Secondly, we are having issues primarily with product that
Electronics Forum | Wed Dec 15 16:17:30 EST 2010 | rgduval
Sounds like there may be a people problem somewhere in your process. We have a couple of checks set up to aid with capturing first article issues. First, of course, the kit is checked against the BOM to ensure that all of the parts match. Then, we
Electronics Forum | Fri Feb 25 02:30:32 EST 2011 | pkannan
Dstadem, Thanks for bringing your in valuable experience with the J STD 005 " Requirements of Solder Paste". I fully agree with you that the Solder Paste can be qualified for shelf life by doing simple viscosity test and visual inspection for coal
Electronics Forum | Thu Aug 11 15:11:35 EDT 2011 | davef
Franx: In response to your follow-up questions ... For the case 1: Q1: Should I apply the glue to the PCB with the same method as I apply solder paste? (with screen printer and squeegee). A1: Correct. Glue can be stencil printed, dispensed, or pin t
Electronics Forum | Fri May 11 09:56:58 EDT 2012 | cyber_wolf
Paste control is a subject that has a lot of unfounded claims surrounding it. What is the difference in having a "working paste jar" and a "new paste jar" Either way new and old are getting mixed at some point. We just don't buy onto the whole thing
Electronics Forum | Thu Feb 07 12:37:42 EST 2013 | phase1
Resistor/Caps using package library Match-45% White pixel solder-25% search window-25% Tant caps custom teach checking for pattern/value Do you also put a polarity band check in there or just check the value and click the polarity box? same passing
Electronics Forum | Wed Feb 20 15:20:34 EST 2013 | hegemon
Depending on your requirements, you could range from a hair dryer, heat gun, toaster oven, hot plate, on up to digitally controlled surfaces and convective systems. You'll have to gauge for yourself whether you are just trying to add some heat energy
Electronics Forum | Wed Mar 20 16:10:27 EDT 2013 | woodsmt
Most pots have a drain system, but that is a scary thing to use. I have seen places that have plumbed it nicely with ball valves and such to control the flow into small containers, but still fraught with danger. I use small metal bread pans. I lad
Electronics Forum | Wed May 22 19:10:47 EDT 2013 | anvil1021
We do a lot of these devices and I guess I am not familiar the term "Dry Solder". The QFN device is not designed to have a drain hole, but needs to have thermal vias to control heat in most cases. We have used every possible gnd pad design and modifi
Electronics Forum | Fri Jun 07 10:28:23 EDT 2013 | danselness
We use a Wave Solder Plated Through Hole (PTH) assembly process to install a TO-220 Chip Package in the PCB board that we manufacture and have experienced lower yields on a number of boards with this component due to Bridges. The bridges on the TO-22