Electronics Forum | Tue Dec 31 02:04:19 EST 2019 | sssamw
From the picture, I cannot see clearly solder ball violate electrical clearance or cause a short, maybe it is. What I can see is the solder paste has some misalignment although it doesn't printed in solder mask area, but actual position will reduce
Electronics Forum | Wed Jan 01 22:19:33 EST 2020 | sssamw
Solder ball attached on solder joint without violation minimum electrical clearance is acceptable. If your process parameter including stencil not changed, suggest you check if solder pasted being pushed out after IC placement, also check if solder j
Electronics Forum | Fri Jan 03 11:37:24 EST 2020 | emeto
Sometimes might be internal change with personnel. Issue is actually there, but if no one questions it-it is not an issue. With 7mil stencil there is a good chance to have solder balls. So were they registered or were they fixed/cleaned?
Electronics Forum | Sat Feb 06 07:14:40 EST 2021 | agoesfirmanto
Dear Sirs, very sorry being late reply after a year. Thank you very much for your advices, you are absolutely correct after reduce grounding pad size. No more solder ball issue. Thank you very much. highly appreciate all of your supports. Best re