Electronics Forum | Mon Aug 09 04:15:33 EDT 1999 | Jacqueline Coia
I am having cleaning problems when processing PCB's which have TAIYO solder mask on them. After processing, hand soldering and cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other soldermasks do no
Electronics Forum | Wed Jan 05 14:45:14 EST 2000 | Hoyt Moore
Does anybody know how to remove solder mask from pads that were masked over.
Electronics Forum | Fri May 21 09:48:30 EDT 2010 | tomg_fla
Am looking for a dispensable water soluble solder mask or peelable solder mask that can be dispensed and be run through a reflow oven with no swelling or degradation. Any leads on any materials or manufacturers to contact?
Electronics Forum | Wed Dec 18 08:38:17 EST 2002 | davef
Thanks Tim. Additional thoughts are: * We've talked here on SMTnet about hole fill previously. * That your ability to get hole fill is probably limited by mask in the hole makes us very uneasy, because hole could have varying levels of solder mask i
Electronics Forum | Wed Nov 20 01:38:53 EST 2019 | ajspec
Hi, i'm facing solder mask peel off but limited to the solder defined pad only(opening area). no peel off on the other area and it happened on electroless nickel immersion gold finishing only. for other finishing is not affected. kindly advise if you
Electronics Forum | Tue Oct 19 19:44:19 EDT 2010 | laen
I'm looking to mix up a batch of purple solder mask. Has anyone found a good ratio of red and blue that produces a pleasing purple? 50/50 produces a pretty ugly grape color. Is there a standard ratio most fabs use?
Electronics Forum | Tue Dec 10 13:35:34 EST 2019 | scotceltic
I am looking to see what people are using for a min-max range to supply your PCB fabricators regarding solder mask thickness. I saw some points in the archives but not too much regarding what people are providing as their spec ? Any help would be a
Electronics Forum | Wed Dec 11 11:35:15 EST 2019 | dilogic
Just out of curiosity - what is the rationale behind specifying mask thicknes?
Electronics Forum | Wed Dec 11 13:00:07 EST 2019 | slthomas
Excessive mask thickness also can wreak havoc on stencil printing.
winsouce.jpg)
