Electronics Forum | Thu Dec 23 11:46:38 EST 1999 | g cronin
I am looking for a vendor for solder spheres and tack flux for BGA reballing. Preferibly on the east coast or new england area. My current distributors have them but require a min purchase of 200,000 that's a lot of balls!!!! thanks greg
Electronics Forum | Thu Dec 23 16:42:52 EST 1999 | Wayne Bracy
Check out Aeroquip there website is www.aeroquip.com/spheres/default2.htm or contact MSD in New Hampshire at (603) 774-5894 Regards, Wayne Bracy
Electronics Forum | Mon Dec 27 17:47:27 EST 1999 | Rob Thomas
A more efficient and cheaper way of reballing bga's would be to use the Solder Quick bga preforms made by Winslow Automation. It is a very simple process .I've been using it for over six months and it works fine.They have a website winslowautomation.
Electronics Forum | Tue Feb 17 18:17:28 EST 1998 | John Wilson
I am looking for any information or testing data done on the amount of weight that can be held by a bga package based on size of the solder sphere and number of spheres. I am reflowing components with a bga package on the opposite side and looking f
Electronics Forum | Mon Nov 01 16:22:47 EDT 2010 | jax
Who Cares... Mix Away! Although you should not mix different Solder Pastes' together in a container or on a stencil (Mostly due to the flux, although solder sphere size and shape could cause an issue), mixing solder brands or chemistries on a board
Electronics Forum | Wed Jan 14 23:08:19 EST 1998 | Ron Costa
Place your components directly on the PCB without using solder paste,unless your using high temp. solder spheres then you should use paste. If eutectic solder spheres are used try fluxing the BGA area and attach it directly to the board. This will re
Electronics Forum | Wed Oct 07 15:46:36 EDT 2020 | tamasmagyar
Hi Hearse, I currently use a MY600, with a AG Ejector which can place dots between 0.33 and 0.52 mm. The differences for a MY600 with placing small dots is down to ejector and paste. To be able to place dots as small as 0.25 mm, you would need an
Electronics Forum | Wed Mar 01 16:59:44 EST 2000 | Dave F
Robert: Expect a 0.033" raw ball to be within 0.022" of the pad, after reflow. To be clear, that�s not a matter of shrinking by 33%. The volume of solder on the pad is the same as the volume of solder in the raw ball. It�s just that the solder is
Electronics Forum | Wed Mar 01 16:59:44 EST 2000 | Dave F
Robert: Expect a 0.033" raw ball to be within 0.022" of the pad, after reflow. To be clear, that�s not a matter of shrinking by 33%. The volume of solder on the pad is the same as the volume of solder in the raw ball. It�s just that the solder is
Electronics Forum | Tue Feb 29 21:53:46 EST 2000 | Kelvin Chow
Dear Robert, On PBGA assembly, BGA sphere shrinkage number depends to the following factors, a. BGA Sphere size (before reflow) b. Solder mask opening diameter As far as I know, no formular has been established yet. Most of my friends just collect
winsouce.jpg)