Electronics Forum | Thu Aug 21 09:05:07 EDT 2003 | davef
Use a cartridge that's approved [conform to OSHA 42 CFR 84] to provide respiratory protection against organic vapors, chlorine, hydrogen chloride, sulfur dioxide, chlorine dioxide, and hydrogen fluoride with a P100 particulate filter which is effecti
Electronics Forum | Thu Feb 09 20:12:51 EST 2017 | imarkl
Any advise about dewetting defect occurrence during 2nd pass reflow. Commonality on affected PCB having water marks near affected pad(s). Elemental composition found on affected pads without solder paste are Silicon and Sulfur. As well as in pad with
Electronics Forum | Wed Feb 21 19:55:12 EST 2001 | davef
References on corrosion are: * "ASM Corrosion Handbook No. 13" [0871700077]. * "Electronic Packaging and Corrosion" ME Nicholson [0871702916]. Please explain how you determined that you have silver-sulfide contamination. Where is the silver comin
Electronics Forum | Tue Nov 29 17:18:26 EST 2022 | davef
Yes, electronics manufacturing is a volume producer of cardboard waste. If the components are ESD-critical, cardboard and most plastics are not ESD safe. Static charges can be generated on these materials during handling by the friction of dissimila
Electronics Forum | Wed Feb 22 08:31:42 EST 2006 | davef
Q1 Are there any standard regulating the subject? Very few infos found on IPC. A1 We�re unaware of standards for packing and storage for most types of boards. * IPC 4553 standard for Immersion Silver Finish, 3.8 Packing and Storage. * J-STD-033 and E
Electronics Forum | Sun Sep 21 10:55:52 EDT 2008 | vladig
As long as the surface is solderable, you should be fine. Silver tarnish a well0-known thing. Make sure, though, there is no sulfur (S) "around". Regards, Vlad
Electronics Forum | Thu Sep 27 19:52:28 EDT 2001 | davef
All of the discussion of "environmental controls" are a matter of degree, dependent on the requirements of the product that you manufacture. For example: shops assembling under-the-hood products have different requirements than shops making garage d
Electronics Forum | Wed May 27 21:05:30 EDT 1998 | Steve Gregory
Hey yooze guys! Enough of the jokes between you and Earl (GRIN), let's get back to the topic...well, okay... you can tell a few more...(but good ones, 'kay?) Anyhoo...I'm not sure if ya'll are on the IPC Technet list or not, I've not seen any posts f
Electronics Forum | Fri May 21 12:24:21 EDT 1999 | KA Stillings
I normally handle the soldering issues for this facility but a question was asked of me -- What the H@## is this stuff and what is causing it? Was wondering of I could get some input from any Guru on plating issues. Need info ASAP!!!!!!!!!!!!!!!!!!!
Electronics Forum | Thu May 28 07:25:58 EDT 1998 | Earl Moon
| Hey yooze guys! | Enough of the jokes between you and Earl (GRIN), let's get back to the topic...well, okay... you can tell a few more...(but good ones, 'kay?) | Anyhoo...I'm not sure if ya'll are on the IPC Technet list or not, I've not seen any p
