Electronics Forum: solder unit error unix (Page 1 of 1)

MYDATA My9 Theta error

Electronics Forum | Tue Nov 13 12:02:54 EST 2012 | jaimebc

I'll try swaping cards and see if the problem follows the card. So far, my guess would be the motor going bad. I did change the brushes, X wagon cables and every cable that goes to the midas unit. But that didn't fix it. The problem is that to replac

Japan Unix Destop Soldering Robot

Electronics Forum | Mon Mar 23 15:54:19 EDT 2015 | g2garyg2

Hi George - Better late than never. Nice units but also look at the cost of weekly consumables. Apollo is about the same but their new Comet units being slightly lower on tip costs and PROMATION is the lowest cost of ownership. Send samples to be sol

Solder briding on QFP

Electronics Forum | Tue Mar 09 11:10:31 EST 2010 | baildl632

Graceyt, I know you are being shot a lot of info. Have you gotten any resolution to this problem? I've seen similar problems in our thermal chamber with Demodulation units. The IC, in the module, inside the radio inside the chamber at the top of ou

Spray Fluxer Problem

Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi

Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave

Re: Bottom side bridging

Electronics Forum | Wed Apr 15 15:04:18 EDT 1998 | D. Lange

We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no proble

In search of knowledge

Electronics Forum | Tue Oct 16 10:06:46 EDT 2012 | jackofallmasterofnone

Hello all, First off let me start by introducing myself. My name is Dan and I work for a contract manufacturer. During a job search I had heard from a previous co-worker that there was a packing job available at the facility where he now worked. I

Re: Pb Free Products

Electronics Forum | Thu Sep 23 12:30:52 EDT 1999 | Wolfgang Busko

I am attemping to gather as much information on the issues with and progress in solutions for manufacturing Pb free products in response to European initiatives (WEEE). I am intereested in component issues with As Made lead terminations (n

Re: Pb Free Products

Electronics Forum | Thu Sep 23 12:43:27 EDT 1999 | Earl Moon

I am attemping to gather as much information on the issues with and progress in solutions for manufacturing Pb free products in response to European initiatives (WEEE). I am intereested in component issues with As Made lead terminations

Re: Pb Free Products

Electronics Forum | Sat Sep 25 08:00:11 EDT 1999 | Brian

I am attemping to gather as much information on the issues with and progress in solutions for manufacturing Pb free products in response to European initiatives (WEEE). I am intereested in component issues with As Made lead termination

Re: Pb Free Products

Electronics Forum | Sat Sep 25 11:05:08 EDT 1999 | Earl Moon

I am attemping to gather as much information on the issues with and progress in solutions for manufacturing Pb free products in response to European initiatives (WEEE). I am intereested in component issues with As Made lead terminati

  1  

solder unit error unix searches for Companies, Equipment, Machines, Suppliers & Information

Sell Your Used SMT & Test Equipment

ONLINE IPC Training & Certification
best reflow oven

High Throughput Reflow Oven


Inspection mirrors for electronic rework and repair.
PCB separator

Low-cost, self-paced, online training on electronics manufacturing fundamentals