Electronics Forum | Tue Jun 06 14:31:42 EDT 2000 | Jeff Sanchez
I have 25#'s of bismuth in my shop. I wanted to add some to my 63/37 till it was eutectic. This would allow me to lower the waves temp. Can I do this and still meet standards? Also would it make the solder joints to brittle and would discoloration be
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Tue Jun 06 14:34:22 EDT 2000 | Charles Harper
Please refer to prior answer recommending contact with Dr. Jennie Hwang.
Electronics Forum | Wed Aug 20 16:56:14 EDT 2003 | adlsmt
Thank you!
Electronics Forum | Wed Aug 20 18:08:32 EDT 2003 | davef
We use a respirator when ever we handle dross.
Electronics Forum | Thu Aug 21 08:30:19 EDT 2003 | adlsmt
Dave, what type? Where do you get them? Thanks!
Electronics Forum | Thu Aug 21 12:16:35 EDT 2003 | adlsmt
Thanks for the info!
Electronics Forum | Tue Aug 19 17:55:28 EDT 2003 | adlsmt
Anyone have a good source for respirators, gloves, aprons etc. for working on wave solder machines? Is there some industry standard for what is required?
Electronics Forum | Thu Aug 21 09:05:07 EDT 2003 | davef
Use a cartridge that's approved [conform to OSHA 42 CFR 84] to provide respiratory protection against organic vapors, chlorine, hydrogen chloride, sulfur dioxide, chlorine dioxide, and hydrogen fluoride with a P100 particulate filter which is effecti
