Electronics Forum | Wed Feb 15 16:24:57 EST 2006 | slthomas
I don't understand the issue with Kapton as long as you put a slight load on the tc so it can't lift. It takes a little more tape but it seems to work. Not as well as HT solder but much more convenient.
Electronics Forum | Thu Feb 16 04:25:49 EST 2006 | pavel_murtishev
Good afternoon, Readings from thermocouple fixed by kapton tape only are inaccurate. This is the fact. At least you need to fix thermocouple with aluminum tape covered by kapton tape. Pete C is right. High temperature solder connection is a preferre
Electronics Forum | Fri Feb 17 18:33:08 EST 2006 | mika
Paste In Hole "PIH" or Pin In Paste "PIP" are two different names of the same process. As far as I know this is fairly simple: the reason from the beginning is to avoid an extra process step/steps in the production line. That is to produce through h
Electronics Forum | Thu Feb 16 12:41:50 EST 2006 | fredericksr
Hey folks, I was interested in any information that you might have on tombstone reduction when using a lead free solder and profile. Thanks for any input that you may have! -Russ #x
Electronics Forum | Mon Feb 20 13:29:44 EST 2006 | patrickbruneel
Great work Amol, Please keep us posted about the results of the x sectioning. I personally don't believe that the cracks are due to non-eutectic properties of SAC. Because the alloy is only 4�C off eutectic and when a solder joint exits the solder
Electronics Forum | Mon Feb 20 20:47:59 EST 2006 | davef
We assume your stencil is clean. So, try: * Reduce stencil separation speed. * Reduce squeegee pressure. If the pressure is not proper, excess number of particles are stuffed into an aperture and inner pressure / friction among particles increase, an
Electronics Forum | Wed Feb 22 21:53:25 EST 2006 | paligora
Thank you Masri, that article was a real eye opener, quite usefull, basic and easy to understand.
Electronics Forum | Wed Feb 22 08:36:07 EST 2006 | Loco
A bit of a handyman can open the mole's batterypack and solder in some new batteries, so dont let the batterypack be a big factor in a comparison.
Electronics Forum | Tue Feb 21 10:51:55 EST 2006 | russ
Does anyone know of a source to get an existing stainles solder pot coated to handle Pb free?
Electronics Forum | Wed Feb 22 04:07:04 EST 2006 | slaine
who rejected it? , sounds like an average leadfree solder joint. you could section it to help prove its good.