Electronics Forum | Tue Oct 17 12:33:49 EDT 2000 | Casimir Budzinski
I am looking at geting a used wave solder machine the one I have been looking at is a Dover Soltec Maxi 6522C with drum spray fluxer, Combi wave, and Nitrogen. If anyone has anything good or bad to say about this wave I would like to know thanks
Electronics Forum | Mon Oct 16 11:53:35 EDT 2000 | Howard C. Ohlhous
I would like to know what type of glue is used to hold down surface mount devices to boards before/during solder reflow. I would like to obtain said glue for evaluation and possible use in an assembly procedure. Please Advise: What company manufactur
Electronics Forum | Mon Oct 23 14:05:08 EDT 2000 | Aokilab
Hi Soza: As Dave F mentioned, there are lot of factors involving the formation of residue, after cleaning. Factors, (such as: solvent's cleaning power, presence of metal oxides, type of soldering flux, etc...). One thing pretty sure, IPC is usually
Electronics Forum | Wed Oct 18 17:11:27 EDT 2000 | Dave F
Stephano: Our supplier specification sheets define 0 to 50�C operating temperature for most devices. Sheets for other devices to 70(75?)�C. Storage for the first group is 0 to 65�C. Heck, why don't you float a couple the puppies and check their o
Electronics Forum | Wed Oct 11 12:52:10 EDT 2000 | Antonio A. Medina
Hello all, I'm new at this so forgive me if my question seems common knowledge to everyone else. I've searched the archives but found no clear answer to what exactly is aspect ratio and what the best ratio is. All I really know is that it has to d
Electronics Forum | Wed Oct 11 09:23:06 EDT 2000 | Roger Squires
Has anyone had any success in finding open circuits (i.e. ball present but not soldered to PCB) under collapsible BGA's using an Agilent HP5DX x-ray tester and the BGA2 algorithm? Can anyone recommend an elongated pad design which produces the neces
Electronics Forum | Thu Oct 05 17:05:36 EDT 2000 | JAX
These types of foil kits work just fine as long as they are used before expiration. Scraping off the epoxy coat gets a little tough on fine pitch pads and etches. I have always like to use a solder sample board to retrieve my bits & pieces from whene
Electronics Forum | Thu Oct 05 09:31:41 EDT 2000 | Daniel
Hi! Does anyone have experience from PCBs with mixed technology. Do you store the PCBs in nitrogen/dry air cabinetts if you�re not able to wavesolder the PCBs within the same day. What considerations need to be taken concerning popcorning/delaminati
Electronics Forum | Wed Oct 04 12:26:36 EDT 2000 | Ashok Dhawan
Not to offend anyone - as this message is not a technical question. I am looking for spare parts for Soltec Wave Soldering Machine Model 6527 Galaxy I. Can anyone advise on sources to get " Used Equipments or spares " ? I need CPU 942/943 Card and
Electronics Forum | Tue Oct 03 16:55:26 EDT 2000 | Chris
Does anyone have any recomendations for a NC flip chip attach flux? I have info from Indium and Kester. Who else makes a good flux for flip chip. I will be dispensing this flux using a doctor blade and rotating disk. I will then dip the flip chip