Electronics Forum | Tue Apr 14 20:28:03 EDT 2015 | carlosdugay123
Hello Marshall, I represent Metal Etch Services, we manufacture SMT Single and Multi-Level Stencils, we have over 25 years experience and one of the reasons most of our customers like us is because we offer technical assistance. Regarding the issue y
Electronics Forum | Wed Feb 25 09:09:24 EST 2015 | spoiltforchoice
Are we talking a professional device that takes something like the Squink/Voltare/EX1 projects on Kickstarter and delivers something that could be confidently used commerically? Would it be strictly a prototyping tool or would it also be suited to lo
Electronics Forum | Mon Mar 23 16:28:14 EDT 2015 | aqueous
Dendritic growth is always a result of three combined factors: Conductive/corrosive residues Electrical current Moisture A wave solder process normally applies a higher volume of flux than a printed process. Flux however is not the only source. F
Electronics Forum | Sat Jul 25 18:35:33 EDT 2015 | orbitcoms
I am looking for information regarding setting up an SMT assembly line. I have recently purchased a stencil paste printer, pick and place, and reflow oven. The main information I need is the paste selection and best finish material on the PCBs. I wil
Electronics Forum | Sat Aug 29 21:42:46 EDT 2015 | sarason
When I made my previous reply, I don't think I was very clear in what I said, so like any politician I will rephrase my response to the question. My intent was that the board didn't have enough soak time leading up to final reflow. So what was happen
Electronics Forum | Fri Dec 04 05:47:57 EST 2015 | rushpcbuk
In PCB design, a BGA (Ball Grid Array) package typically determines the number of layers that a Printed Circuit Board should have. However, the 4-layer board with a BGA package is commonly used than a 2-layer than an 8-layer PCB. On the other hand, t
Electronics Forum | Thu Jan 14 04:41:29 EST 2016 | saimen
Hi There , Glad to contact with you , Here is Saimen in Tianweisheng , wish we will have a good cooperation in the furture if we have the honor . Our company is one of the largest custom-made PCB manufacturer in China. We can OEM,ODM,EMS single side
Electronics Forum | Fri Jun 03 09:17:00 EDT 2016 | designhaus
Hi, > > if I were you, I would probably go for > testing and rework equipment. Adding > manufacturing to your business, will most > probably exceed your preliminary expectations. > Manufacturing is much more complicated than you > probably thin
Electronics Forum | Thu Jun 09 20:48:07 EDT 2016 | deanm
I'm assuming these are two leaded axial components. GPD Global makes fluid dispensing and component prep equipment. Component leads can be formed (or bent) in order to provide some resistance in the hole during insertion. This should prevent the comp
Electronics Forum | Tue Jul 19 10:28:21 EDT 2016 | mrk
What kind of oscillator are you placing (Manufacturer part #)? I do not believe that oscillators fall under the "chip component" category. Even if they did, most all SMT oscillators that I have come into contact with have 1 sided terminations on the
