Electronics Forum | Tue May 11 22:20:42 EDT 2004 | davef
Solder ball problems has to be one of the most popular topics on SMTnet. There is hundreds of postings on the topic in the fine SMTnet Archives. For instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=15669
Electronics Forum | Mon May 10 22:49:45 EDT 2004 | snehal acharya
Hi to ALL, pls give the details about Selective solder M/C Manufacturer.(site detials),if any one knows. regards, Snehal
Electronics Forum | Fri May 14 14:08:04 EDT 2004 | bwet
Perhaps you can try to use the new StencilQuik(TM) technque as it more easily facilitates solder balls dropping onto the pads. Info at http://www.solder.net/stencilquik.asp
Electronics Forum | Tue May 25 14:20:47 EDT 2004 | spray fluxing
If you are beginning a new evaluation of fluxes, make sure you consider an ultrasonic spray fluxing system with recipricating head. A fluxer from Ultrasonic Systems can add valuable data to your wave solder process
Electronics Forum | Mon May 24 08:14:59 EDT 2004 | jdumont
Good morning all, I was wondering if there is a solderability spec or something our purchasing department can order the parts to? Id like to be getting in the best (cleanest, tinned) parts possible to rule out any problems with that before I start at
Electronics Forum | Mon May 24 10:17:37 EDT 2004 | Sue PH
Our old Trieber Wave Solder machine is needing it's conveyor chains to be cleaned. Does anyone out there have knowledge to share about dealing with this problem?
Electronics Forum | Wed Jun 09 15:09:29 EDT 2004 | dwoodrow
Does anyone out there use anything besides alcohol in their automatic claw/finger cleaners in their wave solder machines? We are nearing our VOC limit and are looking into other chemicals (VOC-free) for cleaning. Thanks David
Electronics Forum | Fri Jun 18 11:36:55 EDT 2004 | jdumont
Does anyone have any experience using AIM NC298, or any new NC solder paste from AIM in general. I have no experience with AIM and would like to give them a try. Thanks in advance JD
Electronics Forum | Thu Jun 24 09:24:03 EDT 2004 | Rob
The smallest component we use is 0402. Solder paste is Kester 256. Printer is MPM Ultraprint 2000. Stencil is 6 mil. I didn't here anything bad (rework or whatnots) in terms of soldering of those components.
Electronics Forum | Thu Jun 24 02:31:24 EDT 2004 | yukim
Currently we are having a lot of solder balls, after a few hours of continous production. This is how we work: load new solder paste at the beginning of the shift, less than 500grms. Then, the operator loads new solder paste periodically, every 3 to
