Electronics Forum | Fri Jul 30 09:57:56 EDT 2010 | bwet
= 3 x 3mm http://www.solder.net/stencilmate.asp Inputs would be appreciated! BWET
Electronics Forum | Mon Aug 02 12:28:41 EDT 2010 | tselvan
to prevent solder paste printing defects
Electronics Forum | Tue Aug 03 15:54:35 EDT 2010 | keiths487
we use a cyberoptics lsm 300, which IMO provides good service
Electronics Forum | Tue Aug 10 06:26:00 EDT 2010 | cunningham
We have 2 Koh Young systems and they perform just great
Electronics Forum | Tue Aug 17 11:45:05 EDT 2010 | kjs123p
The best way that I have found is to use homeplating on my stencils.
Electronics Forum | Mon Aug 23 13:59:18 EDT 2010 | swag
Under a scope, make sure the PCB has soldermask between pads.
Electronics Forum | Mon Aug 30 08:38:46 EDT 2010 | rgduval
We appreciate your desire to find the most time effective method of reworking these boards. However, we believe that your most efficient method will be to have one assembler remove all of the parts, and a second assembler place/hand solder the parts
Electronics Forum | Mon Aug 30 11:09:13 EDT 2010 | davef
Lots of small parts, lots of hand soldering, lots of tired eyes inspecting on lots of boards: yields lots of room for error. How about this: * Part removal ** Cut each resistor between the pads using dykes ** Using a soldering iron [or hot air pen],
Electronics Forum | Thu Sep 02 10:18:01 EDT 2010 | davef
GooGone followed by a water wash
Electronics Forum | Wed Sep 08 05:51:24 EDT 2010 | 15009
SIPAD solid solder deposit solves this challenge.
