Electronics Forum | Tue Jun 08 15:04:06 EDT 1999 | JohnW
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Wed Feb 17 15:56:22 EST 1999 | Tuffty
| Dear Al, | Are these reworked, double-sided boards? | | If you attempt to clean side #2 of double-sided misprint in a "spray" type cleaner, millions of solder balls can be broadcast throughout the same chamber as the populated side #1. Or, if thi
Electronics Forum | Sat Jan 16 03:06:36 EST 1999 | Wirat S.
| | Our spec on voids is 30% ball diameter in the center. On the component to ball and pad to ball interface, we use 25%. To determine this spec, we asked around. I don't know of any studies that have been done to verify if this is OK | | | | Regard
Electronics Forum | Tue Sep 22 10:52:31 EDT 1998 | Wayne Bracy
| We have problems with voids when we solder lids to | ceramic flatpackages. | The sealring of the package is gold(100 micro inches or 2.5 micro meters)with a underlayer of Nickel | The solder is attached to the lid (preform) and the solder material
Electronics Forum | Wed Jun 03 21:25:33 EDT 1998 | John Allan
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Thu Jun 04 08:32:21 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Thu Apr 16 13:50:49 EDT 1998 | Lou
| We are having some difficulty soldering a 240 pin Altera device. We use Alpha WS-609, a very generic profile for that solder paste, and a 6 mil stencil with laser cut apertures (1:1 ratio). This is a 20 mil pitch device (aperture size is 10 mils X
Electronics Forum | Thu Apr 16 13:47:36 EDT 1998 | Lou
| We are having some difficulty soldering a 240 pin Altera device. We use Alpha WS-609, a very generic profile for that solder paste, and a 6 mil stencil with laser cut apertures (1:1 ratio). This is a 20 mil pitch device (aperture size is 10 mils X
Electronics Forum | Wed Nov 01 07:32:33 EST 2006 | davef
What you have run up against is the unfortunate consequence of the transition period from Sn-Pb to Pb-free. In the past 2-3 years there have been several studies highlighting the differences in reliability between mixed metal systems, Sn/Pb, and SAC
Electronics Forum | Fri Feb 18 11:24:52 EST 2011 | pkannan
The following is my opinion on the Shelf life of the Solder paste. Comments are welcome to support or against it. Solder Paste users often have the issue of Shelf life expiry condition. Companies including big MNCs, order certain quantities, but du
