Electronics Forum | Tue Jul 06 18:16:14 EDT 1999 | Boca
| | Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area.
Electronics Forum | Fri Jun 25 09:51:35 EDT 1999 | C.K.
| Dear John/Earl | | Thanks for your clarifications. To me also the problem does not seem to be linked with the PCB. The Pre heater temp. is set at | 450 degree C. We are using Alpha Aq. cleanable flux. Can you elaborate on the Desired profilin
Electronics Forum | Wed Jun 23 16:54:16 EDT 1999 | Frank Frimpong
| Do anyone have any experience on assembling high frequency product, 1.8GHz or 2.4GHz. | | In our production line, we manufacture 1.8GHz product with using no clean paste (RMA type) for reflow and no clean wire for rework. In our functinal test,eit
Electronics Forum | Fri Jun 18 10:59:37 EDT 1999 | Scott Cook
| A user of one of our components exceeded the floor life of some plastic BGA components. They did do a pre-bake prior to SMT reflow but only 72 hrs at 40C and not the recommended 12 hours at 125C. I've recommended accoustic microscopy to look for po
Electronics Forum | Thu Jun 17 06:04:48 EDT 1999 | Ron G. Belliard, EET
RE: Cracked Capacitors: I have worked for 3 1/2 yrs with SMTA and have found a similar problem with capacitors. Throughout my studies of the problem, I have discovered three contributing factors that caused this cracking either individually or in co
Electronics Forum | Wed Jun 09 15:54:16 EDT 1999 | Glenn Robertson
| | Does anyone have thoughts on BGA rework. We now use the OK BGA 3000 and now am considering an Infrared machine. Any thoughts? | | | I've used Pace, Conceptronic and, now, SRT machines. Bottom side IR is OK. Better thermal balance is achieved wit
Electronics Forum | Wed Jun 09 17:53:06 EDT 1999 | Tom B.
| I am interested in seeing how some of you quote smt work. Currently we quote off a bom without component packages known then look in data books to find out what type of component they are. This job will be mine soon but i really believe there is a
Electronics Forum | Fri May 21 12:24:21 EDT 1999 | KA Stillings
I normally handle the soldering issues for this facility but a question was asked of me -- What the H@## is this stuff and what is causing it? Was wondering of I could get some input from any Guru on plating issues. Need info ASAP!!!!!!!!!!!!!!!!!!!
Electronics Forum | Thu May 20 18:08:57 EDT 1999 | DEON NUNGARAY
| hello...can somebody help me regarding the POPCORN at Reflow. What is this POPCORN at reflow, what it looks like, its cause and corrective action if there is... | | your help is greatly appreciated...thanks | | omat marasigan | Deon Response:|
Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find