Electronics Forum | Thu Jun 25 09:29:01 EDT 1998 | Henry Lee
| | I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will so
Electronics Forum | Wed Jun 24 14:08:34 EDT 1998 | Henry Lee
I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will solder
Electronics Forum | Thu Jun 25 08:30:39 EDT 1998 | Earl Moon
| I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will sold
Electronics Forum | Thu Jun 25 09:29:01 EDT 1998 | Henry Lee
| | I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will so
Electronics Forum | Fri Jun 12 14:31:04 EDT 1998 | Earl Moon
| | Hey all! | | The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a
Electronics Forum | Wed May 27 16:02:32 EDT 1998 | Chrys
| We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized to
Electronics Forum | Tue May 19 12:54:55 EDT 1998 | Richard Jackson
| We had a similar problem. But whenever the solder came from the screen printer the solder would wet to the gold fingers, with the help of residual flux. But the problem is balls, that I assume are not wetted to the gold fingers but instead are jus
Electronics Forum | Tue Jun 09 00:53:06 EDT 1998 | Dave M
| | | Last week I posted a message on rotary chip waves that stated that the drive shaft had a protective boot around a u-joint that degraded and exposed the joint. | | | Someone from the manufacturer read it and contacted me. He told me the problem
Electronics Forum | Fri May 15 21:59:42 EDT 1998 | Earl Moon
| Hi, | There has been a lot of disputes in our company | about changing present HASL to another Finishing | which can provide more flatter pad surface in fine | pitch applications. ( perhaps Ni/Au, OSP ) | The target is to reduce solder defects, t
Electronics Forum | Mon May 11 17:35:01 EDT 1998 | Steve Gregory
On 11 May, 1998 Todd wrote: | We are having continuous bridging problems with the trailing | leads on a 26-pin D-sub through-hole connector. The pitch is | 0.100". The connector is going through the wave at approximately | a 20 Degree angle. Does
.gif)
