Electronics Forum | Thu Oct 26 12:13:16 EDT 2000 | Steve Thomas
I'd like to respond here not just to throw in my $.01 (I yield at least a penny to the more knowledgeable contributors), but to verify that my thoughts on this are reasonable... How about, you either do in-process inspection or testing, or you valid
Electronics Forum | Fri Oct 27 03:52:39 EDT 2000 | JohnW
Dave, you know the problems about working for a CEM all tose wonderful customers and managers love their graphs! Got 1 eng manager that is pushing everything to double sided reflow (even if the card ain't designed for it!) as he's insisting glue ain
Electronics Forum | Tue Oct 17 13:37:54 EDT 2000 | dpoling
We have this same model and are very disappointed with it. It has several issues that we do not like: 1. The solder feeder has never worked properly. 2. The fingers are very soft material and bend easily. 3. There is no way within the machine to adj
Electronics Forum | Tue Oct 17 01:42:34 EDT 2000 | Peter Carry
Dave, That's the funny thing, thru all that the output was pretty consistant with at least one bridge per board. * The ICs are going thru the wave in-line, according to IPC-782 figure 3-9, "Preferred IC Orientation". * Flatness of second wave is cont
Electronics Forum | Fri Oct 20 13:57:35 EDT 2000 | Greg Amero
Most LCD manuf. specify not to wave or reflow. I believe this is because of the prolonged exposure to the preheat temp. However, about three years ago, we were running about 350/wk of a 40P DIP LCD through the wave with no fallout. It did stress t
Electronics Forum | Wed Oct 11 16:05:16 EDT 2000 | NLykus
Does anyone have any experience with running a double sided/surface mount(bottom)board manufactured with CHEM 1 material? We are currently looking at cost cuts. My personal experience recently in running a D.O.E. against other materials and solder
Electronics Forum | Wed Oct 11 09:55:10 EDT 2000 | Ian Harrison
Some boards that are populated by one of our subcontractors are getting a white powdery residue forming on them. I think it is the non clean flux and process which they are using that is causing the problem. Their process is as follows. Flux is put i
Electronics Forum | Fri Oct 06 09:25:57 EDT 2000 | Kev Head
Most places I've seen don't do anything special. But then again most places only have chip components on the bottom of their boards along with some thru-hole. The best way to find out if you are going to delaminate is to talk to the board manufactu
Electronics Forum | Wed Oct 04 14:46:46 EDT 2000 | Kal. Chak.
Hi folks, What are the differences between Epoxy resin(ER)conformal coating and adhesive stacking/bonding material? My PSA/PRA (Post solder/reflow assembly)bracket assembly process got some ER adhesive encroachment on pads/solderjoints. I have chec
Electronics Forum | Fri Oct 06 08:48:11 EDT 2000 | CAL
NJEV- You can contact me off line for my opinion on the Easi line :caldon@smtnet.com. Compared to past products this one was weak. Missing parts, Screws sticking out, the thermo-sensor was right next to the button so the longer you held the button th
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437