Electronics Forum | Fri Jun 12 23:52:42 EDT 2015 | armandogomez
Reflow? or Wave solder? or selective wave solder? For what I understand you problems is with the preheaters you have a high temp that dries up the flux, and when hits the wave is doing that, do you have a thermal profiler? what's the temp just befor
Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining
I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.
Electronics Forum | Tue May 23 02:32:33 EDT 2017 | bukas
hello Zac, if you are running pump at 100% and there is not enough wave then you will probably need to empty solder bath and clean everything. also check pump parts for tear and wear. eached solder inlet can make a lot of problems when it comes to w
Electronics Forum | Mon Oct 09 05:57:33 EDT 2017 | jamesbarnhart
Reflow profiling/soldering is a process in which a solder paste (a sticky mixture of powdered solder and flux) is used to temporarily attach one or several electrical components to their contact pads, after which the entire assembly is subjected to c
Electronics Forum | Fri Dec 01 15:22:46 EST 2017 | kojotssss
Recommended land and solder pattern says: VIA wall plating, via holes should be tented with solder mask on the backside and filled with solder. Solutions at this moment ? Thanks for all :)
Electronics Forum | Tue Oct 23 17:16:57 EDT 2018 | reckless
Will it not work for soldering defects (solder bridges, shorts, insufficient solder, solder void) or components defects (lifted lead, misaligned component)?
Electronics Forum | Fri May 31 10:15:30 EDT 2019 | davef
Major sources of crack in the solder connection after thermal cycling are: * Thermal heating caused by differences in thermal expansion between the board and the component * Lead-free solder is more rigid and brittle than eutectic solder in simila
Electronics Forum | Thu Aug 01 11:43:57 EDT 2019 | slthomas
I noticed that your solder mask registration is off some. Does it cover a significant portion of any of the pads for these parts? If so, is it possible that the surface tension of the solder at liquidus is enough to skew the part when the solder i
Electronics Forum | Fri Sep 20 11:11:12 EDT 2019 | SMTA-Ernest
Are you interested in trimming pre-solder or post solder? Roto Form Corp. which I believe is located in Tennessee. This machine incorporates a small rotary cutting head for post solder trimming. Otherwise pre-solder trimming is required suggest co
Electronics Forum | Thu Nov 21 19:55:38 EST 2019 | myke03o
Would like to know what type of soldering iron you are using. On this type of big jumpers, a continuous heating soldering Iron will do the job nicely in order to heat the jumper wire properly.
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437
