Electronics Forum | Wed Jun 13 06:42:14 EDT 2012 | brettrenishaw
We have a problem with our Unleaded wave solder machine only randomly soldering some pads. I have looked at the flux level and that appears fine aswell as cheking the preheat and solder height in the bath. The probelm is not exclusive to one perticul
Electronics Forum | Mon May 06 12:20:09 EDT 2013 | davef
Gold in solder alloys can be brittle. We always used to talk about keeping gold LT 3% in order to avoid embrittlement. Some military contracts require removal of gold from soldered contacts. Adding gold to a solder alloy that you're familiar with wi
Electronics Forum | Mon Jun 10 13:31:29 EDT 2013 | emeto
Is there anything on the other side of the board? If not the process will be very standard. 1. SMT - place the small parts on your board. It is called surface mount technology. Basically one machine applies solder paste on the board, another machine
Electronics Forum | Mon Jul 29 19:39:57 EDT 2013 | hegemon
No problem running lead free without nitrogen. Careful profiling will take care of the soldering. Cosmetically, the Nitrogen reflow is superior for lead free, and we see much better wetting, better coverage of the PWB pads, and of course the smooth
Electronics Forum | Fri Oct 04 16:08:28 EDT 2013 | hegemon
Same idea but simpler execution. Verify Solder pot temperature. Verify Temperature of Solder as it leaves the nozzle. Verify preheating gets your PWB up to 90C-120C prior to soldering. Check machine speed, verify 4 seconds contact with solder at
Electronics Forum | Thu Jan 09 19:55:14 EST 2014 | padawanlinuxero
Hello! I have a problem with one of the products here, we use a pallet to run the board on the solder wave, when the board gets solder and you inspect the board you notice that for some reason the first pcbs that touches the wave are ok, even a litt
Electronics Forum | Fri Oct 02 09:22:24 EDT 2015 | derrikf
The following is representative of on-board temps of a FR4 at .069" thickness. The thermal couples were soldered directly to the board using high-temp solder. Again, the halogen-free solder requires an identical profile to our old solder. We had grea
Electronics Forum | Mon Dec 21 09:58:34 EST 2015 | dyoungquist
We are using Metcal STTC-8xx series tips. One thing that makes a huge difference on tip life is what type of solder you are using. If you are soldering with lead (SnPb) solder the tips will last 3 times longer on average than if you are soldering w
Electronics Forum | Mon Nov 13 14:58:56 EST 2017 | davef
Determine the origin of the solder * Sloppy paste printing technique * Lax stencil underside cleaning practices * Sloppy misprint cleaning practices * Poor part placement practices creating solder balls * Poor material control allowing solder p
Electronics Forum | Wed Aug 01 08:58:02 EDT 2018 | 2219576
Please check the solder paste height near PCB edges, Please check board clamping during solder paste printing. Please check tooling support boards must be fixed during the printing process. try to set wiper cleaning frequency and fine tune for best
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437