Electronics Forum | Wed Dec 04 04:28:58 EST 2019 | oxygensmd
It seems there isn't right connection between solder and solder-legs. Maybe check that the LEDs get huminidity, have some oxidation on the legs, try different solder paste, check the reflow solder profile. On the photo I can not saw properly reflowe
Electronics Forum | Thu Dec 05 05:39:05 EST 2019 | oxygensmd
I know your application isn't BGA but the data sheet also mention about the peak temperature - 235 Celsius. For the LEDs you can reach higher temperature and I recommend to reach 225-235 Celsius. You will get significantly better results because the
Electronics Forum | Thu Nov 30 20:41:35 EST 2000 | Roland
Larry, SMTnet.com did an Onboard Forum regarding lead free solder. The link : http://www.smtnet.com/onboard/get_forum.cfm?session_id=4& Also, I did a search of the SMTnet forum (left side of most pages-please be patient it takes a moment) using th
Electronics Forum | Mon Apr 16 12:59:51 EDT 2001 | Mike R
If you will place a temperature strip on the board during wave soldering process you will get a max of 210 F or 98.8 C which is normal on the standard wave temperature. The problem on the 10% solder on the TH via hole can be caused by insufficient fl
Electronics Forum | Fri Apr 23 07:58:21 EDT 1999 | Vinesh Gandhi
We are an assembly house engaged in large volume manufacturing of Computer motherboards and others. We are in the process of selection of a new wave soldering machine. Can somebody help me inform what are the different parameters which must be ensur
Electronics Forum | Tue May 07 22:25:15 EDT 2002 | L_ch
Hello, As you know for the double side assembly PCBs, we normally first place the bottom side, then place top side after reflow soldering of bottom side. are there any other considerations for the sequence of reflow soldering ( bottoms side first, to
Electronics Forum | Wed Feb 12 20:13:39 EST 2003 | cmiller
Does anyone have any experience with setting up a nitrogen supply system to a wave solder machine that is equiped for it? Does the nitrogen need to be room temp or higher? Does it make a big difference with bridging or solder quality? We bought a use
Electronics Forum | Fri Feb 21 08:41:06 EST 2003 | davef
Yes. Reflow soldering PTH components goes under different names. * SMTnet's friend Bob Willis popularized the "intrusive reflow soldering" term. * Jim Blankenhorn, another of our friends, and others popularized "pin and paste". * Still others use
Electronics Forum | Wed Jun 11 15:57:39 EDT 2003 | pjc
Frank, ECD (WaveRIDER) and Datapaq (Optimiser) have wave solder machine process control devices. They will check the following: 1. Conveyor speed 2. Preheat Temps 3. Solder Temps 4. Wave Dwell/Contact Times 5. Wave Heights 6. Waves Parallelism Go
Electronics Forum | Tue Jun 17 01:45:30 EDT 2003 | Dreamsniper
Hi, All these guys have provided you good solid infos already! All I can say is that check your wave solder machine's mechanical set-up too...and the Molten Solder Level in the bath must be maintained at an accurate level/height specially after ded
A US manufacturer of quality hand tools for those engaged in the repair, rework, R & D, testing, and assembly of electronic components and printed circuit boards from Through Hole to 2Mil Pitch Surface Mount.
98 Elm St.
Portland, ME USA
Phone: 1-207-775-6139