Electronics Forum | Mon Jul 29 16:55:50 EDT 2013 | mbb
The temperature should be
Electronics Forum | Tue Jan 14 08:48:09 EST 2014 | davef
I don't know. What does your paste supplier say? You can run tests * That you used to qualify this paste in the first place. * According to IPC J-STD-005A Requirements for Soldering Pastes * Using your toughest stencil to print this paste on a bare c
Electronics Forum | Wed Mar 12 15:26:46 EDT 2014 | dan_ems
Hello, in my SMT process I have some problems with the solderability (look like dewetting) on a PCB with finish HASL Lead Free with a composition that is melt at 230 degree Celsius. My oven is with vapor phase and the peak temperature is 230 degre
Electronics Forum | Tue Mar 25 02:58:24 EDT 2014 | molder
ok.. thanks you so much.. I will buy new dispenser siringe, and I try to rework... I have a questions on desolder and solder a socket 1366 intel on motherboard. I have a rework station Honton hot air and tornado infrared, but i don't know a temperatu
Electronics Forum | Tue Apr 22 12:33:35 EDT 2014 | barryg
No we have a battery spring that is soldered directly to a PCB (standard tin plated copper PCB). The Battery spring supplier (and I have no confirmation he makes them or buys them) claims they are tin plated. When trying to solder to them it is very
Electronics Forum | Wed Oct 29 18:18:34 EDT 2014 | jorge_quijano
Hola Grayboard, I've had the same situation with these components, I changed the stencil apertures a little bit and use a stepped stencil (5-6mil), after some trials we were able to get decent yields, but we still had some failures, what we discover
Electronics Forum | Tue Nov 25 05:20:20 EST 2014 | grimus
Could be. I am making overprint to achieve proper amount of solder paste inside hole. Now I am trying to reduce maximum overprint and compensate it with step - up stencil. This could reduce effect that some particles of solder paste are not gathering
Electronics Forum | Wed Aug 12 17:18:03 EDT 2015 | dyoungquist
Here is our solution: We run the assembly line 40 hours per week and use 500g cartridges of solder. We take 1 cartridge out Monday morning and leave it out until the end of the Friday shift when it is put back into the refrigerator. That means you
Electronics Forum | Thu Aug 13 13:48:22 EDT 2015 | markhoch
Hi Juan, I think if you check your Solder Paste's Data Sheet, you will find that your Solder Paste can be stored at Room Temperature for up to four weeks. There is no need to put your paste back into the refrigerator after every shift. If it makes
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437
