Electronics Forum | Sat May 06 06:58:13 EDT 2000 | Wayne S.
Hello, I am looking for a small solder pot with a fountain or wave. I have seen mini-waves but would like to find something smaller and less expensive. Would like to dip solder wires to small bulb leads. If anyone has any suggestions please follow-
Electronics Forum | Wed Jul 27 18:41:48 EDT 2005 | crishan
Aj, You are correct, we use pallets to hold the motherboard, an X-Y table then transports the pallet through preheat section to the solder bath. I will check out your recommendations on the solder alloy. Supplier is not willing to share PPM data o
Electronics Forum | Fri Nov 09 10:37:38 EST 2007 | devajj
We have started using QFN packages in large volume and are having problems with no-solders. We are using 6mil stencil with 1x1 paste print to pad. These also have thermal pads with thru vias that we reduce the stencil aperture by 1/4. Board also ha
Electronics Forum | Thu Nov 29 22:10:53 EST 2007 | lito_visaya
To anyone with extensive reflow experience, We have an 8-zone reflow intended for reflow soldering of our lead-free models, but sometimes, we use the reflow for soldering of non lead-free. Does it holds true that our lead-free products may be c
Electronics Forum | Tue Jun 23 19:16:04 EDT 2009 | jmelson
Are you sure there is any "cleaning" needed? Can you see leftover bits of the teflon remaining? If so, work on it with an Xacto knife. But, most thermocouple wires are VERY hard to solder - as in practically impossible. Many of them have aluminum
Electronics Forum | Sun May 09 22:23:21 EDT 2010 | aungthura
Hi Josh yes, the cost of galden is a big concern because the machine should be run 12 hrs for 6days.Besides, we more concern in socket soldering by vapor because our socket can stand only for 30sec in 210'C temp.Meanwhile, we do socket soldering by w
Electronics Forum | Fri Jul 10 11:10:16 EDT 1998 | Boris Akselrud
Hi all, I am new to SMT. In past I've made many PCB boards with my small hands at home, but I've used regular technology drilling the holes for the components. I am trying to use SMT for my projects. SOP packages I was able to solder using a regular
Electronics Forum | Tue Jul 26 23:02:22 EDT 2005 | crishan
Hello, We currently have huge quality issues with our Inertec selective solder machine, the model we have does not pump solder, rather the solder bath is raised to the product. We have continuing issues with bridging and non wetting of joints. We a
A US manufacturer of quality hand tools for those engaged in the repair, rework, R & D, testing, and assembly of electronic components and printed circuit boards from Through Hole to 2Mil Pitch Surface Mount.
98 Elm St.
Portland, ME USA
Phone: 1-207-775-6139