Electronics Forum | Tue Jun 01 11:51:48 EDT 1999 | Dave F
| We have experienced problems with chlorine damaging certain components, is there anyone with similar problems and possible solutions ? preferably info about a source for chlorine free solder paste | | Thanks | | James | James: There is no chlor
Electronics Forum | Mon May 31 19:20:50 EDT 1999 | Raeto Zryd
I have difficulty to convince my management to air-condition our manufacturing facilities. The room temperature fluxuates from 8 deg.C in the morning to 25 deg. C in the afternoon. The PCB topside temperatures in the reflow oven and wave soldering ma
Electronics Forum | Fri May 28 15:50:48 EDT 1999 | Frank Boyko
We now put soldermask on copper and then immersion nickel/gold plate our fine line boards. One of our vendors says this causes skipped plating in small via holes and wants to nickel/gold plate the whole board, including via holes, and then apply sold
Electronics Forum | Wed May 26 09:56:46 EDT 1999 | Robert Wells
we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any obvio
Electronics Forum | Thu Apr 29 19:52:32 EDT 1999 | WinTech mfg
I would like to know if there is any good training for Hand Soldering, Component Identification, Wave Soldering, and so on. I have seen two diffenent tapes and they were short and poorly done, I would like to buy some if I knew it had some good Trai
Electronics Forum | Wed Apr 28 14:17:20 EDT 1999 | Bob Willis
| Anyone using hot air nife for wave soldering process. | Does it work? | Does it really eliminate solder bridging and does it create any other problems? | | any feed back will be much appriciated. | | Thanks | | Tony A | | I have a article I p
Electronics Forum | Wed Apr 28 14:17:32 EDT 1999 | Bob Willis
| Anyone using hot air nife for wave soldering process. | Does it work? | Does it really eliminate solder bridging and does it create any other problems? | | any feed back will be much appriciated. | | Thanks | | Tony A | | I have a article I p
Electronics Forum | Tue Apr 27 16:04:00 EDT 1999 | Frank Boyko
We use Immersion Gold (AuNi) for our 20 mil pitch and BGA boards. Lately, we have been having solderability problems with boards with this surface from some of our suppliers. We are considering trying boards with White Tin solderable surfaces such D
Electronics Forum | Fri Apr 23 14:19:39 EDT 1999 | C.K.
Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free soldering on these guys.
Electronics Forum | Fri Apr 23 11:31:35 EDT 1999 | J.J. Thomas
A customer told me that pad geometry was to be different depending on soldering process. I think this is untrue. What is stated in the IPC - SM -782 standards is that parts should be placed to elimanate a trailing edge. This however should not e
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437