Electronics Forum | Fri Jan 09 09:43:48 EST 2009 | boardhouse
Hi Simon, The main reason that it would probably be removed would be do to lack of clearance for a soldermask dam from pad to pad. typically if the clearance from pad to pad is under .008 the solder mask dam would be removed. Min recomended dam siz
Electronics Forum | Wed Jun 01 15:50:59 EDT 2011 | markhoch
I don't believe that particle size of the solderpaste will offer you any relief from this issue. The solder flows into the via, leeching away from the desired solderpoint, after the solder has become liquious. The chemical make-up of the solder contr
Electronics Forum | Sat Sep 14 01:34:19 EDT 2002 | Yngwie
I have the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcoming designs? 2) What are the manufacturi
Electronics Forum | Tue Sep 17 00:40:39 EDT 2002 | yngwie
Hi all Experts, Desperately need your help on the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcom
Electronics Forum | Thu Feb 06 09:53:38 EST 2003 | genny
Actually, the most common reason I have seen vias in pads is for grounds in RF applications where the frequencies are high enough that you need a ground RIGHT THERE!... not .1" away. Vias and traces have RF properties of capacitance and inductance,
Electronics Forum | Fri Sep 13 06:18:55 EDT 2002 | yngwie
Here's a long survey....Pls help. 1) What is the general feel for via in pad for upcoming designs? - complete Via in pad - partial encroachment - via partially in pad 2) What are the manufacturing bare PCB's related concerns, issues and possible dr
Electronics Forum | Tue Jan 08 09:23:18 EST 2013 | lock_2002
This is a question regarding soldermask between pins of fine pitch devices. The majority of our production designs end up with at least 2-3 mils of copper thickness on the external layers due to blind vias, wrap plating requirements, etc. Our curre
Electronics Forum | Sun Oct 01 23:58:55 EDT 2000 | stuartfd
Dear forum types, 1st timer so be good. I have a customer in China using Coates soldermask that in its self is not a problem. The problem is the flux their using, I think,it appears to have a vary high viscosity. The problem they have laid at my door
Electronics Forum | Tue Jun 13 21:57:01 EDT 2000 | Dave F
Todd: You say: "... solder masking between the lands of fine pitch components can cause stenciling problems and or manufacturing problems." I say: Fine pitch components without solder masking between the lands can cause stenciling problems and o
| 1 |
