Electronics Forum | Wed Mar 01 07:45:56 EST 2006 | davef
Consider: * Equipment Inspection acoustic microscope [Scanning Acoustic Microscopy (SAM)] MicroPhotonics 4949 Liberty Lane, Suite 160, PO Box 3129 Allentown PA 18106 610.366.7103 fax 7105 http://www.microphotonics.com * Equipment Inspection acoustic
Electronics Forum | Wed Apr 14 14:48:48 EDT 2010 | davef
It won't work. An acoustic signal can't punch through a BGA. The signals reflect at every interface. So, it works for flip chip, but there are too many interfaces in CSP and BGA. Equipment, Inspection, Acoustic microscope * MicroPhotonics * Sonos
Electronics Forum | Mon Jan 21 15:45:05 EST 2008 | davef
Yes. It's called a surface acoustic microscope. Rent time at your local university or college.
Electronics Forum | Tue Jul 31 20:00:08 EDT 2001 | davef
SUPPLIERS: * Sonix 8700 Morrissette Dr Springfield, VA 22152 (703) 440-0222 ext 155 fax 9512 John Goings * Sonoscan 2149 E Pratt Blvd Elk Grove Village IL 60007 800.950.2638 630.766.7088 fax 4603 http://www.sonoscan.com info @sonoscan.com John Ippen
Electronics Forum | Thu Jul 14 16:38:13 EDT 2005 | sleech
Our present lab went "South." We need a lab that can do temperature/humidity conditioing, convection oven baking, C-Mode Scanning Acoustical Microscopic package inspection and "No-Pb" reflow simulation. We are evaluating a low temperature package dry
Electronics Forum | Fri Mar 30 14:47:27 EDT 2007 | GS
MSL 3) By SAM (Scanning Acoustic Microscope) before to remove them from PCB, you could identify if de-laminated or not and the degree of delamination. Best Regards...GS
Electronics Forum | Wed Apr 30 12:30:14 EDT 2003 | Guillermo
Hello, I would like to ask for cooments/advices about the inspection of small solder deposits inspection (aprox 4 mills). We tried with X ray and Scanning acoustic microscope but it looks like due to the small size, we could not be sure to get all t
Electronics Forum | Wed Oct 03 17:06:43 EDT 2001 | davef
Yes, moisture entrapment causes solder shorts 80% of the time. Cracks occur bottom side of the BGA. Use an acoustic microscope to find the cracks. So, what makes you think your BGA are blowing-off steam? I posted a vid on SMTnet that showed the b
Electronics Forum | Fri Jun 16 18:48:57 EDT 2006 | GS
Hi Grant, just my opinion, I think the concern could be related to the extra temperature the BGAs have been exposed during the Lead Free Reflow Temperature. So you need to check ( data sheet) what is the max temperature and how long the Pb/BGA can w
Electronics Forum | Wed Sep 02 08:44:50 EDT 1998 | Kelly Morris
| Hi, | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent it.
.gif)
