Electronics Forum | Thu Nov 28 09:42:51 EST 2002 | Claude_Couture
MPM SP200 are nice. Visual alignment with cameras. Get the one with dual head if you want metal squeegees. We have produced boards with .020" fine pitch with very good results. Unfortunatly, MPM does not sell those anymore, so you have to hunt for a
Electronics Forum | Mon Dec 02 08:39:07 EST 2002 | pjc
The MPM SP200 was replaced by the model SPM around 1994. They also have the model UP100, which is from the SMTech purchase. The UP100 is the low-end MPM semi-automatic. Information on the SPM & UP100 can be found at http://www.cooksonee.com
Electronics Forum | Fri Nov 11 11:02:23 EST 2005 | russ
i would look at an SPM from MPM(speedline) or an SP200 from Europlacer (speedprint not speedline) We have used both of these machines with great success from 16mil pitch qfps to .5mm pitch uBGAs.
Electronics Forum | Thu Aug 12 18:43:49 EDT 1999 | Wayne S.
Hello Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening 100 durometer blade. Getting "tails" on deposits. Trie
Electronics Forum | Thu Aug 12 20:17:12 EDT 1999 | Kelly Morris
| Hello | | Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening | 100 durometer blade. Getting "tails" on deposi
Electronics Forum | Wed Feb 23 22:56:46 EST 2011 | jeffr
When I enter the "Setup Table Contact" menu, then press "Load PCB" the squeegee head should move to a mid position that I can set the squeegee height, but instead it moves the squeegee head to the front limit and displays a red error message about th
Electronics Forum | Tue Nov 15 16:31:04 EST 2011 | pcbrown
Can anyone tell me if the Metcal SP200 solder station meets the J-STD-001 Rev E requirement of holding a tip temp of +/-9F at rest? I am in a fight with an auditor over this. These irons do not require calibration but I need to know if they meet J-ST
Electronics Forum | Mon Jan 30 06:29:44 EST 2006 | robls
We are a Contract Manufacturer in South Africa. We currently have a Speedprint SP200AVI fully automatic printer with 2D vision etc etc. We require a second fully automatic printer and are busy evaluating a DEK Horizon 03i. We have found good points
Electronics Forum | Fri Aug 13 12:52:17 EDT 1999 | Steve Schrader
| Hello | | Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening | 100 durometer blade. Getting "tails" on deposi
Electronics Forum | Tue Aug 17 10:41:13 EDT 1999 | Steve A
Wayne, Sounds like a gasketing problem. When the horizontal apertures are bleeding but not the vertical apertures. Could be poor underside support, HASL miniscus issues, masking or plugging issues, but what many people do not account for is that t
.gif)
