Electronics Forum | Mon Nov 16 11:33:38 EST 2020 | spoiltforchoice
For basic task like merging BOM with centroid file I use SMT-Maestro or my own tool that does the same thing. As with RobD above this gets your data into a fairly standard consistent format from where I would hope your Juki tools can take over. To cr
Electronics Forum | Wed Apr 28 15:23:47 EDT 2021 | procyon
Hello Deni, Thanks for the comment. Could you provide a bit more information as to what pins are used to accomplish this specifically for Universal Instruments Blue label older feeders? Here is the pinout I got from UI but it does not show a statu
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64
Electronics Forum | Fri Jun 04 11:54:22 EDT 2021 | cbart
We do this quote often with our older Summit machine. there are a few ways to do this. all of these are assuming you have parts on the boards already and are working around them. 1- if you have a good tech that can add solder to the pads on the PCB a
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Tue Feb 14 08:49:34 EST 2023 | tommy_magyar
Hi there. I did work with Viscom AOI/AXi combo models for nearly 5 years, ones like X7056. It is fairly easy to understand programming if you have proper training from them - read more about black and white image processing in case you would like to
Electronics Forum | Mon Mar 27 13:37:44 EDT 2023 | spoiltforchoice
I haven't run either. However when were looking at machines; MyData (MY100) was exactly the class of machine that fitted our use case. There were plenty of installations with comparable use cases to ours and plenty of those have multiple lines and ar
Electronics Forum | Fri Jun 02 23:53:16 EDT 2023 | calebcsmt
In both IPC standards, it is referenced: "When 'X' standard is cited or required by contract, the requirements of 'X OTHER' do not apply unless separately or specifically required." I've always understood J-STD to be the act of assembling, where A-6