Electronics Forum | Tue Dec 02 06:07:00 EST 2014 | sarason
A trick I used to use doing RF design was to have on the edge of a panel, a stripline that I could hook up to a Network Analyser to check board impedance. You could do this to verify if the fault is in the no wash process or a board manufacture proce
Electronics Forum | Fri Jan 02 13:24:00 EST 2015 | deanm
I understand the Camalot and Mydata both have a maximum board length of 20". How do you/would you process a board over 20" as mentioned you sometimes have 49" boards? If a screen printer is an option, have you seen the ESE US-LX3 which has a maximum
Electronics Forum | Mon Mar 16 12:44:36 EDT 2015 | proy
soldering a very simple board in a very simple Accuheat oven. Can anyone give me basic starting point settings (conveyor speed and temperature) then we will profile using a mole from there. Paste 1) Tin Lead Paste 2) Chipquik low temp TL 165C PR
Electronics Forum | Wed Apr 01 08:23:05 EDT 2015 | emeto
All you have to do is to go on the floor when the machines are running and see yourself what the speed is. All machines show this data and even more. Most machines show some statistical data too - you can dig a little bit into that and you will get y
Electronics Forum | Fri May 01 21:10:22 EDT 2015 | sarason
They are probably getting a little hot. So that leaves several courses of action. 1: Don't place them before reflow and hand finish. 2: Shield them with a little folded shield to decrease heat transfer. 3: Speed up the time through the oven, but th
Electronics Forum | Tue May 19 13:29:33 EDT 2015 | dyoungquist
We have been running a Heller 1707EXL for 8 years and added a Heller 1707MKIII about 1 years ago. We have not had any problems with either one of them. We do both lead and lead-free assemblies along with BGA/LGA components. If speed/volume is not
Electronics Forum | Mon Jul 20 10:50:31 EDT 2015 | emeto
Very interesting question you have here. Guess where all the mass production id? -In China. Brazil is still a market for machines. Besides some automotive, US is not really doing mass production any more.
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Tue Feb 16 13:58:02 EST 2016 | tsvetan
this document http://www.latticesemi.com/view_document?document_id=671 may be good start point but note that how to escape from the BGA is not big deal, how to route your filtering capcitors, grounding, impedance control lof you high speed signals ar
Electronics Forum | Thu Dec 29 09:48:24 EST 2016 | emeto
Bruce, I have different size electrolytic caps. Most of them should be no issue to pick 8 at a time(5-6mm) Can't I decrease the speed of the head when placing these parts? I would love to place slow motion 8 parts at a time than going 8 times with t