Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Sat May 27 02:52:20 EDT 2006 | TimS
Gentlemen I have managed to pull myself together after banging my head. I am not sure the flux volume is the total solution here. All spray processes deposit flux in a similar manner, that is to say the vast majority of material sprayed onto the PCB
Electronics Forum | Fri Dec 18 12:14:10 EST 1998 | Brian Steelglove
| | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | Good or bad for high volume Thrue Hole? | | | | Thanks Again, | | Brian Steelglove | | A
Electronics Forum | Fri May 08 16:30:59 EDT 1998 | Chrys
| I am running boards with gold fingers on a pallet for | masking purposes. The pallets worked fine for a while | but know the gold fingers are getting solder on them. We | have tried everythin: new pallets, cleaning the pallet | and board to be s
Electronics Forum | Tue May 19 08:48:05 EDT 1998 | Aric Parr
| | I am running boards with gold fingers on a pallet for | | masking purposes. The pallets worked fine for a while | | but know the gold fingers are getting solder on them. We | | have tried everythin: new pallets, cleaning the pallet | | and boa
Electronics Forum | Tue Aug 13 17:34:44 EDT 2002 | pjc
The Electra is Electrovert's top-of-the-line wave solder machine. Just about the best you could get. Conveyor concerns should focus on the condition of the extruded rails. A machine that new should not have a problem, buy worth a look see. Find out i
Electronics Forum | Fri Oct 03 07:49:18 EDT 2003 | mk
Mask Musings. Soldermask (SM) and its functions have changed and evolved over the years. As an ex-solder mask applicator, I can remember screening Colonial High Gloss Epoxy soldermask on boards back in the early 80's, ending up with a thickness that
Electronics Forum | Fri Jul 04 19:17:37 EDT 2014 | andrespena
Hi (I don't know if this forum is the best place to post something like this, but I don't know of other places on the internet, so... sorry if I'm in the wrong place) Might there be an easier way to add components (e.g. computer chips) to a circuit
Electronics Forum | Mon Dec 21 08:49:29 EST 1998 | Aric Parr
I used one on SMT at a previous employer. Make sure that you have 3 zones of preheat. Make sure that your operators are trained. The airknifes are extremely difficult to set up properly. Don't use them on high mix lines. We didn't need them once
Electronics Forum | Tue Dec 22 10:00:31 EST 1998 | Chrys
| | | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | | Good or bad for high volume Thrue Hole? | | | | | | Thanks Again, | | | Brian Steelg
