Electronics Forum | Wed Mar 10 13:04:10 EST 2004 | jpa
I need to purchase a rework tool mainly for QFP's including 30mm x 30mm. I was looking at a Metcal QX2 and a Pace TF200. I would welcome any comments on these two products or any other suggestions. Also, is a preheater necessary?
Electronics Forum | Thu Mar 11 11:34:09 EST 2004 | babe
The Metcal will run you around $5,000.00. The Pace is over $6,000.00. Check out Hakko model 852/853 for under $2,000.00 If your in the NewEngland area call us we sell them also.
Electronics Forum | Tue Jun 28 19:29:31 EDT 2022 | SMTA-68235204
What are some of the types of tool storage that you use for the assembly work stations?
Electronics Forum | Sat Jul 29 08:47:09 EDT 2000 | lh_zeng
Hi guys, Did any one do evaluation between SRT summit 1100 and Freedom HGR2000 rework station? Hope I can share some experience about advantage and defect of these two product.
Electronics Forum | Fri Dec 19 11:32:46 EST 1997 | Kris Ganev
Can anybody give me feed back on the pro and cons of using Pace, OK, Hakko, Metcal, etc... equipment in their rework processes? I need to set up a low volume rework station for mixed technology boards. Would appreciate any suggestions.
Electronics Forum | Tue Jun 15 15:10:44 EDT 2004 | mrmaint
Looking for feedback on an Airvac DRS24C Bga rework station. Looking for both good and bad feedback. Users only please, no sales folks. Thanks MRMAINT
Electronics Forum | Wed Jul 08 16:01:23 EDT 2015 | goodting
Hi Gentlemen/ladies: Can someone tell me where I can buy a GSM Advantis feeder loading station(for used one)? Appreciated your information. GTing
Electronics Forum | Thu Aug 16 15:29:30 EDT 2001 | steven
When Air-Vac introduced an IR system at a show in San Jose, people though it was the greatest thing since sliced bread. For obvious reasons they discontinued the short life of the IR systems and implemented hot air into their rework stations. Sales
Electronics Forum | Tue Feb 05 16:06:48 EST 2013 | mlevesque
We are looking for a new BGA rework station. We got an ERSA IR550A and we are not very satisfied. I'm not sure that IR reflow is the better solution because the top-side heating is too large. I think is better with a convection "forced-air" heat.
Electronics Forum | Thu Oct 10 17:32:52 EDT 2013 | soscomputer
you're right for sure, but there is some brand like hakko i don't like them why ? because process and menus (controllers) doesn't really give a good result. For example fm206, hot air/desoldering/soldering station doesn't have the real tc. And a lot
