Electronics Forum | Tue Jan 24 18:21:22 EST 2006 | fredc
I have some old Fuji windmills here and I checked the usefull travel. It is approxiamately 1.5mm, the nozzles are suposed to have .3mm "preload" wich will take away from the usable overtravel. The windmill I checked is a reject that from when we rebu
Electronics Forum | Wed May 04 17:15:02 EDT 2005 | siverts
Hey Dr . Klein, I think You do it all right... But here it comes: MSD; what does it really means? MS-level; what does it really means? Floor life what does it really means? I'm sorry but I can't answer all these questions right now. It is a complex m
Electronics Forum | Tue Aug 23 20:46:41 EDT 2005 | darby
If I had my way - the person checking the incoming kit should be able to at least run, troubleshoot and preferably programme the SMT line. In fact they should be an expert.They have the paper work in front of them for that job. If the tape is cut - t
Electronics Forum | Wed Dec 28 16:03:53 EST 2005 | Chris
I have lots of experience with thermosonic gold ball bonding. You can read the literature and you will probably find some papers that say you can do it. I have never been able to do it. We gold ball bond all day long with little problems at all bu
Electronics Forum | Sat Aug 19 21:06:09 EDT 2006 | mika
Hi all, At our Fuji CP-6 machines we place a lot of 0402:s, 0603:s and 0805:s chip capacitors. Our problem is that the height of the components can sometime be very extreme from different vendors. I am sure you all have experience of this phenomenon
Electronics Forum | Sun Jun 06 12:51:34 EDT 2010 | whitewing
Hi - I'm looking into possible low-end pick/place machines (in UK) for prototype/small runs - taking the next step from plastic stencil/hand place/pizza oven, as my local subcontractors can't offer the fast turnrounds I often need for short runs. Bud
Electronics Forum | Sun Jan 30 20:13:32 EST 2022 | chuckphd53
I have a SMT-460 machine that works pretty good for the most part. When placing parts I have an issue with the SOT-23 rotation 90deg. Using both Juki 503 / 504 nozzle it will pick and place all of the 0805 and 1206 resistors/caps just fine. I have 9
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Wed Sep 15 03:11:33 EDT 1999 | Charles Stringer
| | | Hi, | | | | | | Recently encountered missing components problem at the SMT process. | | | Among 13 chip components from the same part number mounted on the board, only 4 ( located in a same row and next to each other) were missing after post r
Electronics Forum | Thu Aug 19 22:59:48 EDT 1999 | Jeff Ferry
| I'm trying a second time to post this very important message, to me, concerning Air-Vac's following creation. Does any own and use this stuff successfully to remove solder from 20 layer and up MLB's with .020" diameter holes? Also, is any of the ad